CS-E18HKDW, CU-E18HKD - Panasonic Air Conditioner Service Manual (repair manual). Page 47

47

1. The compressor will not start for three minutes after stop of operation.
2. This control is not applicable if the power supply is cut off and on again or after 4-way valve deices condition.

1. Once the compressor starts operation, it will not stop its operation for 30 seconds.
2. However, it can be stopped using remote control or Auto Switch at indoor unit.

1. When the outdoor unit total running current (AC) exceeds X value, the frequency instructed for compressor operation will be

decreased.

2. If the running current does not exceed X value for five seconds, the frequency instructed will be increased.

3. However, if total outdoor unit running current exceeds Y value, compressor will be stopped immediately for 3 minutes.

4. The first 30 minutes of cooling operation, (A) will be applied.

A. Overheating Prevention Control

1. When the IPM temperature rises to 110

qC, compressor operation will stop immediately.

2. Compressor operation restarts after three minutes the temperature decreases to 95

qC.

B. DC Peak Current Control

1. When electric current to IPM exceeds set value of 30.0 ± 5.0 A, the compressor will stop operate. Then, operation will restart

after three minutes.

2. If the set value is exceeded again more than 30 seconds after the compressor starts, the operation will restart after two

minutes.

3. If the set value is exceeded again within 30 seconds after the compressor starts, the operation will restart after one minute. If

this condition repeats continuously for seven times, all indoor and outdoor relays will be cut off.

E18HK

Operation Mode

 X (A)

Y (A)

Cooling/Soft Dry (A)

8.8

15.0

Cooling/Soft Dry (B)

7.7

15.0

Heating

10.8

17.0