CS-A28JKD, CU-A28JKD - Panasonic Air Conditioner Service Manual (repair manual). Page 29

29

• Automatic operation can be set using remote control.
• This operation starts to operate with indoor fan at SLo speed for 25 seconds to judge the intake air temperature.
• After judged the temperature, the operation mode is determined by referring to the below standard.

• Then, the unit start to operate at determined operation mode, until it is switched off using remote control, with the setting

temperature as shown in below table.

• Operation mode will be determine again for judgement after 1 hour of operation, if the room temperature reaches to set

temperature and compressor off time is over 7 minutes 30 seconds continuously.

*

The present operation mode will be continued, if the room temperature does not reach to set temperature (Compressor keeps

running) eventhough after 1 hour from automatic operation mode started.

• Automatic Set Temperature

For each operation, set temperature will automatically set as shown below.

• The setting temperature for all the operations can be changed one level up or one level down from the standard temperature as

shown in below table by pressing on the temperature up or temperature down button at remote control.

• The operation mode judging temperature and standard setting temperature can be increased by 2°C permanently, by open the

circuit of JX03 at printed circuit board indoor unit.

Present

Mode

Judgement

Next Mode

Cooling

Soft Dry

Heating

Cooling

O

(Judgement:

23

qC & Above)

Not Applicable

O

(Judgement:
Below 23

qC)

23

qC

Cooling

Heating

Soft Dry

Not Applicable

O

(Judgement:

20

qC & Above)

O

(Judgement:
Below 20

qC)

20

qC

Soft Dry

Heating

Heating

O

(Judgement:

25

qC & Above)

Not Applicable

O

(Judgement:
Below 25

qC)

25

qC

Cooling

Heating

Operation

Hi

(Standard)

Lo

(+2

qC)

(±0

qC)

(-2

qC)

Cooling

27

qC

25

qC

23

qC

Soft Dry

24

qC

22

qC

20

qC

Heating

23

qC

21

qC

19

qC