Read LG WT-Y118SG Service Manual online
9
2-3. CONNECT THE DRAIN HOSE
For pump model
2-4. FLOODING DRAINAGE
For non - pump model
NOTE
Never lay down the drain hose, as water will be discharged.
Be sure the drain hose is properly routed so it will not kink or lift from the sink.
The discharge height should be approximately 0.9~1.2m from the floor.
Connect the drain hose adjusting the length of it not to be dropped. If drain hose
is dropped the drainage could be poor because of blockage in the hose.
is dropped the drainage could be poor because of blockage in the hose.
Connect the drain hose to the outlet of the drain
located at the back side of the washing machine.
located at the back side of the washing machine.
Fix the drain hose with the clip.
And then push it toward the body as in the figure.
Keep it downward while the washing machine is working.
Ensure the hose is free from kinking.
Ensure the hose is free from kinking.
You machine requires a floor drainage slope (or hole) that will SAFELY DISPOSE of the FULL FLOW of any water that
may leak out should the machine malfunction.
It is therefore the OWNER'S RESPONSIBILITY to make sure this machine is installed in an area with a drain hole (or
slope) that will prevent any possibility of water damage to floor coverings or property.
may leak out should the machine malfunction.
It is therefore the OWNER'S RESPONSIBILITY to make sure this machine is installed in an area with a drain hole (or
slope) that will prevent any possibility of water damage to floor coverings or property.
Do not install the washer where it is directly exposed to sunlight, wind, rain, etc.
Plug the power cord of this washer into a properly installed standard power outlet that is grounded.
Your machine requires a floor drainage slope (or hole) that will SAFELY DISPOSE of the FULL FLOW of any water that may leak
out should the machine malfunction. It is therefore the OWNER’S RESPONSIBILITY to make sure this machine is installed in an
area with a drain hole (or slope) that will prevent any possibility of water damage to floor coverings or property.
Permissible water temperature : Max 70˚C (160˚F)
Permissible water pressure : Max 116psi (800 kpa, 8 kg/cm
Plug the power cord of this washer into a properly installed standard power outlet that is grounded.
Your machine requires a floor drainage slope (or hole) that will SAFELY DISPOSE of the FULL FLOW of any water that may leak
out should the machine malfunction. It is therefore the OWNER’S RESPONSIBILITY to make sure this machine is installed in an
area with a drain hole (or slope) that will prevent any possibility of water damage to floor coverings or property.
Permissible water temperature : Max 70˚C (160˚F)
Permissible water pressure : Max 116psi (800 kpa, 8 kg/cm
2
), Min 4 psi (30 kpa, 0.3 kg/cm
2
)
If water temperature and pressure are greater than above, it may cause damage to the machine. If you have uncontrolled water
temperature and pressure you should fit a temperature and pressure relief valve to ensure that water temperature and water
pressure remain within the safe limits. Consult a plumber or electrician if you are unable to adjust water temperature and pressure.
Do not over tighten the coupling nuts with a tool. Inlets are plastic : Do not strip or crossthread.
temperature and pressure you should fit a temperature and pressure relief valve to ensure that water temperature and water
pressure remain within the safe limits. Consult a plumber or electrician if you are unable to adjust water temperature and pressure.
Do not over tighten the coupling nuts with a tool. Inlets are plastic : Do not strip or crossthread.
CAUTION
Hose
Guide
Within 50mm
0.9~
1.2m
Drain Hose
Holder
Holes for the Holder
Push
Holes
For Holder
Connect the drain hose to the
outlet of the drain pump located
at the rear of the washing
machine.
outlet of the drain pump located
at the rear of the washing
machine.
Attach the clip to the drain hose.
And then push it toward the body
of the washing machine as
indicated by the arrow.
And then push it toward the body
of the washing machine as
indicated by the arrow.
Check that the drain hose is hung
up over the edge of the laundry
tub.
Do not use an extension hose.
up over the edge of the laundry
tub.
Do not use an extension hose.
Click on the first or last page to see other WT-Y118SG service manuals if exist.