WP-580N - LG Washing Machine Service Manual (repair manual). Page 10

-10-

1.Untighten the plunger valve cover by rotating in

the direction of the arrow. (fig.25)

The bellows assembly attached to the unit cannot be
separated unless it is torn off.

4. Tighten the bolt of the coupling assembly while

adjusting it to the cutter split made in the spin shaft.
(fig.24)

The assembly procedure is as follows:

1.Insert the bellows assembly into the bellows

supporter.

2.Fit them by pushing the bellows assembly and

the bellows supporter at the same time in the
spin tub bottom. (fig.23)

3.Pass the spin shaft through the center hole of the

bellows assembly and the insert it into the coupling
assembly. (fig.23)

fig.23

fig.25

1.Remove the belllows assembly. (fig.22)
2.Remove the bellows supporter by using slip joint

pliers to the tub bottom. (fig.22)

fig.22

fig.24

If the leakage occurs at the spin tub after
assembling the bellows assembly and the bellows
supporter, it is wrong. It could cause an electrical
shock  or a fire, therefore they should be securely
assembled again.

After separating the plunger valve strap from the
rod proceed as follows:

Bellows assembly

Plunger
valve cover