Read LG WFW1532EK Service Manual online
42
2) Defects on displaying funcion
Where, what & how to check?
Result of Check
Possible Cause
How to repair & settle
Main voltage
1. Measure mains voltage at the wall outlet
2. Meaure voltage at the extended
outlet that the washer is plugged in
if the extended outlet is used and
voltage at the electrical outlet
is normal in the above.
outlet that the washer is plugged in
if the extended outlet is used and
voltage at the electrical outlet
is normal in the above.
Transfomer
1. Measure the secondary voltage of the
transfomer.
Controller
1. Defect of LED.
2. Defect of LED driving circuit.
3. Defect of micom.
2. Defect of LED driving circuit.
3. Defect of micom.
Less than 85% of the
ratingĀ
ratingĀ
Less than 85% of the
ratingĀ
Less than AC 10V
Low voltage
The dia of the lead wire is
smaller or many loads are
connected at the same
outlet
smaller or many loads are
connected at the same
outlet
Defect of the transfomer
Defect of controller.
Change the controller.
Change the controller.
To explain that it is
caused by low voltage in
electric supply and
recommend using a
transfomer if voltage has
been continuously low.
caused by low voltage in
electric supply and
recommend using a
transfomer if voltage has
been continuously low.
To use a transfomer
having a enough capacity
if using a transfomer.
having a enough capacity
if using a transfomer.
3) Reset During operation
Where, what & how to check?
Result of Check
Possible Cause
How to repair & settle
Main voltage
1. Measure voltage of the outlet that the
washer is plugged into during wash and
spin.
spin.
2. Reset symptom happens at specific time
zone repeatedly.
3. Check whether a transfomerlent power
cut happens. (Fluorescent lamp is
transfomeriently blinked)
transfomeriently blinked)
Less than 80% of the
rating.
rating.
Mains voltage is too low
or size of a lead wire is
too small.
or size of a lead wire is
too small.
External noise inrushed.
Explain that it is caused
by low voltage in electric
mains and recommend
using a suitable size of
leads.
by low voltage in electric
mains and recommend
using a suitable size of
leads.
Explain it is caused by
using environment.
(It happens when
equipment with high
frequency is used
around)
using environment.
(It happens when
equipment with high
frequency is used
around)
Explain it is a problem of
electric supply
environment.
electric supply
environment.
Click on the first or last page to see other WFW1532EK service manuals if exist.