WFS0938EPD - LG Washing Machine Service Manual (repair manual). Page 16

 

 

WASHING CONDITION INDICATOR 

START/PAUSE 

● The program can only be executed when it is under the "STANDARD" or 

"INTELLIGENT WASH" mode. It cannot be perceived if 
"WASH","RINSE" or "SPIN" is selected. 

● During sensor, the indicator blinks in the order of green-orange-red. When 

sensor is over, a specific color will be displayed according to the following 
detecting result. 

1. If the washing condition(amount of detergent, water temperature and water 

quality) is superior to standard condition, the micro-processor will 
automatically reduce washing time/strength and the indicator will turn red.。

2. If the washing condition is inferior to standard condition, Micro-processor 

will automatically improve washing time/strength and the indicator will turn 
orange. 

3. If the washing condition is standard, the program remains unchanged and 

indicator turns green. 

● Use to start or pause the 

washing process。 

 
● Repeats start and pause 

by pushing the button. 

 

● Use to turn the power on or off。

●The power goes off 

automatically about 10 

seconds after the wash is 

finished or 10 minutes under 

PAUSE state.

   

 

 

 

●Use to adjust spinning time. 
●Spinning time can be adjusted 

manually according to 
requirements and the time is 
increasing with certain 
sequence as the button is 
pushed. 

●Press "START/PAUSE" button 

before adjusting the "SPIN" 
program. 

  ● Use to set a delayed finishing 

time before a leave to avoid 
wrinkling。 

● The following settings are 

indicated as the button is 
pushed 
3->4->5->….11->12->14->16
…46->48->3 HOUR 

●Use for selecting wash program  。
● This button allows you to select 8 

different programs for different 
kinds of laundry and dirtiness。
Program selections light up in 
sequence as follows: 
FUZZY(NORMAL)→POWER 
WASH→QUICK 
WASH→WOOL→INTELLIGE
NT 
WASH→SILENT→CASUAL 
WASH→TUB 
CLEAN→FUZZY(NORMAL)]

● To cancel delay time, turn the 

power switch off。 

 

4. Sensor sensitivity will decrease after long-time use. Please use "TUB CLEAN" program to clean the inner and 
outer tub。 
5. Even if the water level or temperature is changed during "STANDARD" program, the sensor is still working. 
Inner optimization algorithm varies because of different models。 
6. Control panel may differ according to different models. 
7. "Three-level" mode is available when the water level is between 3 and 8 beside "WOOL" and "TUB CLEAN" 
program. 
 

 16