T1103ADE5 - LG Washing Machine Service Manual (repair manual). Page 7

(NORMAL TAB WITHOUY THREAD & ONE TOUCH TYPE INLET HOSE.)

One Touch Type

        

Separate Middle connector from the Water 
Supply Hose by pulling the Pressing Rod and 
the Pressing Handle that is attached to the
Water Supply Hose while pressing them.

     

Push the upper connector up till the rubber packing is in tight
contact with the tap. 
Then tighten the 4 screws.

       

Remove the fixed sticker in between the Upper 
and Middle Connectors. 
Tighten the connectors by holding one connector 
and twist middle connector to the right.

        

Press down the pressing rod of the Water 
Supply Hose which was separated from middle 
connector(refer to Step1) and then join it to 
the middle connector.

 

!   " !

After connecting the hose, open the tap to
check for any water leakage.
In case of water leakage, close the tap and start
again from step 1.
If you skip step1, it may cause water leakage.

#

Conector
Medio

Etiqueta

Fija

Manija de Presi

ón

Barra de Presi

ón

Manguera de Suministro de Agua

Empaque

de Caucho

Tornillo

Etiqueta

 Fija

Empaque

de Caucho

Placa Gu

ía

Conector

Conector

Etiqueta

Fijada

Conector
Medio

Conector
Medio

Conector

Manguera de Suministro de Agua

Barra de Presi

ón

Mani

a

 de Presi

ón

$             

Untighten the screw of the connector so that the tap can 
be placed in the middle.

In case the tap is large.

If the tap diameter is too large or is square,
open the 4 screw and take out the guide
plate and follow step 1.

%

Fixed Stiicker
Pressing Handle

Pressing Rod

Water Supply Hose

Middle connector

Rubber packing
Screw

Fixed sticker

Guide plate

Connector

Connector

Rubber packing

Connector
Middle
Connector

Pressing handle

Middle
Connector

Fixed sticker

Pressing rod

Water Supply Hose