T1007TEFT - LG Washing Machine Service Manual (repair manual). Page 12

12

• This machine detects the quantity of laundry automatically, then sets the WATER LEVEL and

proper amount of Detergent.

• When you select a wash program, the WATER LEVEL and amount of

Detergent (to be used) will be shown on the control panel.

• The following table shows the amount of water.

•

laundry even though the same WATER LEVEL is indicated on the control panel.

• The machine sets the appropriate temperature automatically according to the wash program .
• You can change the Water Temperature by pressing the WATER TEMP. button. 
• The temperature of the water impacts the e?ectiveness of all laundry additives and therefore, the cleaning results. We

recommend temperatures of:

- HOT 49~60°C…(120-140 F)

White items, diapers, underclothing and heavily soiled, colorfast items.

- WARM 29~40°C…(85-105 F) Most items

- COLD* 18~24°C…(65-75 F)

Only very bright colors with light soil.

• When washing in COLD water additional steps may be needed:

-  Adjust Detergent amount and pre-dissolve Detergent in WARM water

-  Pretreat spots and stains

-  Soak heavily soiled items

-  Use appropriate bleach

* Temperature below 18°C…(65 F) will not activate laundry additives and may cause lint, residue, poor cleaning, etc. In addition,

Detergent manufactures and care labels define COLD water as 26~29°C…(80-85 F). 

 

It depends on laundry load and washer model. Or manually you can pour a certain amount water into tub directly

to some height. That’s because if water level reaches to the some height sensed by washer itself, washer

automatically operates. In other words, it is needed to pour water to the point when washer starts operating.

If iron is present in the water the clothes may become an all-over yellow or they may be stained with brown or

for severe cases.

The dispenser drawer contains 2 compartments:
• Liquid Fabric Softener

• Liquid or Powder Low-Sudsing, High-E?ciency Detergent
The dispenser automatically dispenses additives at the proper time in the wash cycle.
1. Slowly open the dispenser drawer by pulling the drawer out until it stops.

2. After adding laundry products, slowly close the dispenser drawer. Closing the drawer

too quickly could result in early dispensing of additives.

• Avoid overfilling or splashing when adding laundry products to the dispenser. Doing so

could result in early dispensing of laundry products.

At the end of the cycle, you may see water in the compartments. This is part of the normal

operation of the washer.
NOTE : Do not use bleach in the dispenser drawer.