60PZ850-TA (CHASSIS:PA11A) - LG TV Service Manual (repair manual). Page 11

- 11 -

(Pattern Generator MSPG-3233, HDMI mode NO. 371 ,

pattern No. 81)

(1) Please input 3D test pattern like below

(2) Enter 3D mode , then select side by side

(If you don’t wear a 3D Glasses, you will see the picture
like below)

(3) Put on the 3D Glasses, And block the right side of Glasses 

(LEFT:OPEN[TEST], RIGHT:CLOSED)
And check the middle sides of picture , RED -> normal ,
others -> abnormal

(4) Put on the 3D Glasses, And block the right side of Glasses 

(LEFT:CLOSED, RIGHT:OPEN[TEST])
And check the middle sides of picture , BLUE -> normal ,
others -> abnormal

(1) Press “Power on” key of service remocon.(Baud rate :

115200 bps)

(2) Connect RS232 Signal Cable to RS-232 Jack.
(3) Write Serial number by use RS-232.
(4) Must check the serial number at signal test of customer

support. (Refer to below).

CMD

: A0h 

LENGTH : 85~94h (1~16 bytes)
ADH

: EEPROM Sub Address high (00~1F)

ADL

: EEPROM Sub Address low (00~FF)

Data

: Write data

CS

: CMD + LENGTH + ADH + ADL + Data_1 + ... + 

Data_n

Delay

: 20ms

[Description]

FOS Default write : <7mode data> write
Vtotal, V_Frequency, Sync_Polarity, Htotal, Hstart, Vstart,
0, Phase
Data write : Model Name and Serial Number write in
EEPROM,.

(1) Serial number D/L is using of scan equipment.
(2) Setting of scan equipment operated by Manufacturing

Technology Group.

(3) Serial number D/L must be conformed when it is produced

in production line, because serial number D/L is mandatory
by D-book 4.0