50PW450-TD (CHASSIS:PA11A) - LG TV Service Manual (repair manual). Page 11

Read LG 50PW450-TD (CHASSIS:PA11A) Service Manual online

- 11 -
8. Checking the EYE-Q Operation.
(1) Press the EYE Key on the adjustment remote controller.
(2) Check  the  Sensor  DATA  (  It  must  be  under  10)  and  keep
the data longer than 1.5s
(3) Check ‘OK’
(Sensor DATA 0 ~ 4095, Power Saving Mode 0 ~ 12)
* IF you press IN-STAP Button, change Green Eye-check OSD.
9. Ping TEST
(DVB T2 model only, PP11B/L)
* This test is to check Network operation.
(1) Connect LAN cable from Computer to TV Set
(2) When  network  operates  normally,  you  can  see  “OK”  on
Computer
10. 3D Function Test
(Pattern  Generator  MSPG-3233,  HDMI  mode  NO.  371  ,
pattern No. 81)
(1) Please input 3D test pattern like below
(2) Enter 3D mode , then select side by side
(If  you  don’t  wear  a  3D  Glasses,  you  will  see  the  picture
like below)
(3) Put on the 3D Glasses, And block the right side of Glasses 
(LEFT:OPEN[TEST], RIGHT:CLOSED)
And  check  the  middle  sides  of  picture  ,  RED  ->  normal  ,
others -> abnormal
(4) Put on the 3D Glasses, And block the right side of Glasses 
(LEFT:CLOSED, RIGHT:OPEN[TEST])
And  check  the  middle  sides  of  picture  ,  BLUE  ->  normal  ,
others -> abnormal
11. Model  name  &  Serial  number
download
11-1. Model name & Serial number D/L 
(1) Press  “Power  on”  key  of  service  remocon.(Baud  rate  :
115200 bps)
(2) Connect RS232 Signal Cable to RS-232 Jack.
(3) Write Serial number by use RS-232.
(4) Must  check  the  serial  number  at  signal  test  of  customer
support. (Refer to below).
11-2. Signal TABLE
CMD
: A0h 
LENGTH : 85~94h (1~16 bytes)
ADH
: EEPROM Sub Address high (00~1F)
ADL
: EEPROM Sub Address low (00~FF)
Data
: Write data
CS
: CMD + LENGTH + ADH + ADL + Data_1 + ... + 
Data_n
Delay
: 20ms
Page of 36
Display

Click on the first or last page to see other 50PW450-TD (CHASSIS:PA11A) service manuals if exist.