50PC5R-ZB (CHASSIS:PP78A) - LG TV Service Manual (repair manual). Page 14

- 14 -

- Adjustment mode : Two modes of Cool (Dynamic) and

Warm(Mild).
(Medium data is automatically calibrated by the cool data)

- Color analyzer(CA110, CA210) should be used in the

calibrated ch by CS-1000.(PDP : CH10)

- Operate the zero-calibration of the CA-110 or CA-210, then

stick sensor to the module when adjusting.

- For manual adjustment, it is also possible by the following

sequence.

(1) Select RF no signal by pressing “POWER ON” key on

remote control for adjustment then operate heat run more
than 15 minutes. 

(If not executed this step, the condition for W/B will be differ.)
(2) Changing to the av mode by pushing the input or front av

key.(av mode : av1 or av2 or av3)

(3) Display the internal pattern of the VCT-Pro IC by pushing

the IN-START.

(4) Stick sensor to center of the screen and select each items

(Red/Green/Blue Gain and Offset) using 

D

/

E 

(CH+/-) key

on R/C.

(5) Adjust R Gain / B Gain using 

F

/

G

(VOL+/-) key on R/C.

(6) Adjust two modes of Cool(Dynamic) and Warm(Mild) as

below figure.
(Fix the one of R/G/B and change the others)
1. Push the one time the in-start key : Dynamic(Cool)
2. Push the two more the in-start key : Mild(Warm)

* Refer to the below case to know what value is fixed.

* CASE

- First adjust the coordinate much away from the target

value(x, y).

1) x, y > target

(1) Decrease the R, G. 

2) x, y <  target

(1) First decrease the B gain.
(2) Decrease the one of the others.

- In case of decreasing the x, decreasing the R : fix G
- In case of decreasing the y , decreasing the G : fix R

3) x  > target ,  y < target

(1) First decrease B, so make y a little more than the target.
(2) Adjust x value by decreasing the R.

4) x < target ,  y > target

(1) First decrease B, so make x a little more than the target.
(2) Adjust x value by decreasing the G.

(7) When adjustment is completed, Exit adjustment mode

using EXIT key on R/C.

(1) Push the ADJ key in a Adjust Remote control.
(2) Input the Option Number that was specified in the BOM,

into the Shipping area.

(3) The work is finished, Push 

A

Key.

<Default Value on OSD>

Color Coordinate

x

y 

0.283±0.002

0.293±0.002

0.329±0.002

11000K

9300K

6500K

0.000

0.000

0.003

0.276±0.002

0.285±0.002

0.313±0.002

COOL

MEDIUM

WARM

Mode

Temp

uv

Item

Dielectric Voltage (AC <-> FG)

Dielectric Voltage (Without FG)

Value

1.5

1.5

3

3

Unit

kV

kV

Remark

At 100mA for 1sec (Line)

At 100mA for 1min (OQC)

At 100mA for 1sec (Line)

At 100mA for 1min (OQC)

Item

Min

Typ

Max

Unit

Remark

Audio Practical Max Output, L(Mono)/R

9

10

12

W

PDP