Read LG 47LX9500-ZA / 47LX950N-ZA / 47LX9800-ZA / 47LX9900-ZA (CHASSIS:LD03R) Service Manual online
- 14 -
4.4. Wireless function check
Step 1) Connect set and Dongle of Wireless to Cable of HDMI
& TTA 20Pin
Step 2) At OSD of SET, check the message like Fig.3
Step 3) Detach Cable of Wireless Dongle
Step 3) Detach Cable of Wireless Dongle
4.5. EYE-Q function check
Step 1) Turn on TV
Step 2) Press EYE key of Adj. R/C
Step 3) Cover the Eye Q II sensor on the front of the using
Step 2) Press EYE key of Adj. R/C
Step 3) Cover the Eye Q II sensor on the front of the using
your hand and wait for 6 seconds
Step 4) Confirm that R/G/B value is lower than 10 of the “Raw
Data (Sensor data, Back light)”. If after 6 seconds,
R/G/B value is not lower than 10, replace Eye Q II
sensor.
R/G/B value is not lower than 10, replace Eye Q II
sensor.
Step 5) Remove your hand from the Eye Q II sensor and wait
for 6 seconds.
Step 6) Confirm that “ok” pop up. If change is not seen,
replace Eye Q II sensor.
4.6. Local Dimming Function Check
Step 1) Turn on TV.
Step 2) At the Local Dimming mode, module Edge Backlight
Step 2) At the Local Dimming mode, module Edge Backlight
moving right to left Back light of IOP module moving.
Step 3) Confirm the Local Dimming mode.
Step 4) Press “exit” key
Step 4) Press “exit” key
4.7. Magic Motion Remote control test
(47/55LX9500 only)
- Equipment : RF Remote control for test, IR-KEY-Code
- Equipment : RF Remote control for test, IR-KEY-Code
Remote control for test
- You must confirm the battery power of RF-Remote control
before test(recommend that change the battery per every lot)
- Sequence (test)
1) if you select the ‘start key(Mute)’ on the controller, you can
pairing with the TV SET.
2) You can check the cursor on the TV Screen, when select
the ‘OK Key’ on the controller
3) You must remove the pairing with the TV Set by select
‘Vol+(STOP) Key’ on the controller
4.8. 3D function test
(Pattern Generator MSHG-600, MSPG-6100 [Support HDMI 1.4])
* HDMI mode No. 872, pattern No. 83)
1) Please input 3D test pattern like below
* HDMI mode No. 872, pattern No. 83)
1) Please input 3D test pattern like below
2) When 3D OSD appear automatically, then select OK button.
Fi g . 1
< Do ng le>
Fig . 3 Connect the Dongle
( Do ng le Co n n ec t io n Di s p lay)
Fi g . 2
< Wireles s Read y Set >
Connect
Local Dimming Demo (Edge LED Model)
Local Dimming Demo (IOP Model)
Click on the first or last page to see other 47LX9500-ZA / 47LX950N-ZA / 47LX9800-ZA / 47LX9900-ZA (CHASSIS:LD03R) service manuals if exist.