42PG6HD-UA (CHASSIS:PU83A) - LG TV Service Manual (repair manual). Page 9

- 9 -

(1) Execute POWER ON(

Â

) of the adjustment R/C to execute

automatic adjustment. 

(2) Set the Baud Rate to 115200.
(3) Always start adjustment with “wb 00 00” and end

adjustment with “wb 00 ff” 

(4) Adjust the offset if necessary

(1) Required Test Equipment: CA-210 (CH 10), CA-100(CH-

10), CA-100+(CH-10)
=> To adjust color temperature of Plasma, CS-1000 is the

Color Analyzer and should be set to use CH 10 in which
white, red, green, and blue color are corrected. Conduct
the adjustment according to the coordinates for White
Balance adjustment in the table below.

(2) Enter the ‘Ez - Adjust’ by pressing the ADJ on the Service

R/C.

(3) Select 10.TEST PATTERN using the CH + / - KEY and

press the Enter KEY to execute a heat run for more than
30 minutes. 

(4) Execute a Zero Calibration for CA-210 and put it at

distance of less than 10Cm from the PDP module surface
center during the adjustment. 

(5) Select ‘7. White-Balance’ of ‘Ez - Adjust’ by pressing the

ADJ KEY on the Service R/C. Then enter adjustment mode
by pressing the Right KEY (

G

) .

(The internal pattern of full white appears by pressing 

G

)

(6) The adjustment is conducted in three levels of color

temperature; COOL, MEDIUM, and WARM.

-When R Gain is Fixed at Default value(192)

Adjust G gain and B gain with decreasing Default values
from 192

-When B Gain is Fixed at Default value(192)

Adjust R gain and G gain with decreasing Default values
from 192

-When G Gain is Fixed at Default value(192)

Adjust R gain and B gain with decreasing Default values
from 192

One of R/G.B Gain should be fixed at 192 and adjust two
Gain Value with decreasing the Default values from 192.

(7) Use the Vol. +, - key for adjustment.
(8) When the adjustment is completed, press the ENTER (

Á

KEY) button to move to the Ez –Adjust screen. Press the
ADJ KEY to exit the adjustment mode.