Read LG 42LW5600 (CHASSIS:LA12C) Service Manual online
- 18 -
5.4. EYE-Q Check
Step 1) Turn on the TV.
Step 2) Press EYE button in adjust remote control.
Step 3) Stay 6 seconds with Eye Q sensor hidden located on
Step 2) Press EYE button in adjust remote control.
Step 3) Stay 6 seconds with Eye Q sensor hidden located on
the front of the set.
Step 4) Check the “Sensor Data” on the screen and check
whether the value is lower thanafter 6 seconds, the
value does not go below 10, Eye Q sensor is not
working properly. Then, change the sensor.
value does not go below 10, Eye Q sensor is not
working properly. Then, change the sensor.
Step 5) Remove hand from the Eye Q II sensor and stay for 6
seconds.
Step 6) Check whether the “Back Light (xxx)” value has risen
on the screen. If after 6 seconds and the value still
does not go high, the eye Q II sensor is not working
properly. Replace the sensor.
does not go high, the eye Q II sensor is not working
properly. Replace the sensor.
5.5. Magic Motion remote controller Check
5.5.1. Test equipment
- RF-remote controller for check, IR-KEY-CODE remote
- RF-remote controller for check, IR-KEY-CODE remote
controller.
- Check AA battery before test. A recommendation is that a
tester change battery every lots.
5.5.2. Test
(1) Make pairing with TV set by pressing “Mute (START) key”
(1) Make pairing with TV set by pressing “Mute (START) key”
on RCU.
(2) Check a cursor on screen by pressing ‘ENTER” or “OK”
key of RCU
(3) Stop paring with TV set by pressing “VOL+ (STOP) key.
5.6. 3D pattern test
5.6.1. Test equipment
(1) Pattern Generator MSHG-600 or MSPG-6100 (HDMI 1.4
(1) Pattern Generator MSHG-600 or MSPG-6100 (HDMI 1.4
support)
(2) Pattern: HDMI mode (model No. 872, pattern No. 83)
5.6.2. Test method
(1) Input 3D test signal as Fig.1.
(1) Input 3D test signal as Fig.1.
<Step1>
<Step2>
<Step3>
<Step4>
<Step5>
O
K
O K
Fig.1
<HDMI Mode 872, Pattern No.83
Fig.2
Click on the first or last page to see other 42LW5600 (CHASSIS:LA12C) service manuals if exist.