42LK530T (CHASSIS:LD11U) - LG TV Service Manual (repair manual). Page 13

Step 1) Turn on TV
Step 2) Press EYE key of Adjustment remote control.
Step 3) Cover the Eye Q II sensor on the front of the using

your hand and wait for 6 seconds

Step 4) Confirm that R/G/B value is lower than 10 of the “Raw

Data(Sensor data, Back light)”. If after 6 seconds, R/G
/B value is not lower than 10, replace Eye Q II sensor.

Step 5) Remove your hand from the Eye Q II sensor and wait

for 6 seconds.

Step 6) Confirm that “ok” pop up. 

If change is not seen, replace Eye Q II sensor.

• Connect D-sub Signal Cable to D-sub Jack.
• Write EDID Data to EEPROM(24C02) by using DDC2B

protocol.

• Check whether written EDID data is correct or not.
* For Service main assembly, EDID have to be downloaded to

Insert Process in advance.

• Connect HDMI Signal Cable to HDMI Jack.
• Write EDID Data to EEPROM(24C02) by using DDC2B

protocol.

• Check whether written EDID data is correct or not.
* For Service main assembly, EDID have to be downloaded to

Insert Process in advance.

1) All Data : HEXA Value
2) Changeable Data :
*: Serial No : Controlled / Data:01
**: Month : Controlled / Data:00
***:Year : Controlled
****:Check sum

• After enter Service Mode by pushing “ADJ” key,
• Enter EDID D/L mode.
• Enter “START” by pushing “OK” key.

* Caution : Never connect HDMI & D-sub Cable when EDID

download

* Edid data and Model option download (RS232)

* Caution

1) Use the proper signal cable for EDID Download.

- Analog EDID : Pin3 exists
- Digital EDID : Pin3 exists

2) Never connect HDMI & D-sub Cable at the same time.
3) Use the proper cables below for EDID Writing.
4) Download HDMI1, HDMI2, separately because HDMI1 is

different from HDMI2.

- 13 -

EZ ADJUT

0. Tool Option1  
1. Tool Option2
2. Tool Option3
3. Tool Option4
4. Tool Option5
5. Country Group
6. Area Option
7. ADC Calibration
8. White Balance
9. 10 Point WB
10. Test Pattern

11. EDID D/L

12. Sub B/C
13. V-Com

EDID D/L

HDMI1
HDMI2
HDMI3
RGB

NG
NG
NG
NG

Reset

Start

EDID D/L

Reset

Start

HDMI1
HDMI2
HDMI3
RGB

OK
OK
OK
OK

Item CMD1 CMD2 Data0

Download

A

A

0

0 When transfer the ‘Mode In’,

‘Mode In’

Carry the command.

Download

A

E

00 10 Automatically Download

(The use of a internal pattern)

Item

Manufacturer ID

Version

Revision

Condition

GSM

Digital : 1

Digital : 3

Data(Hex)

1E6D

01

03

D-sub to D-sub

DVI-D to HDMI or HDMI to HDMI

For HDMI EDID

For Analog EDID