Read LG 42LG70YR (CHASSIS:LP81D) Service Manual online
5. Adjusting the White Balance
5.1 Purpose and Principle for adjustment of the
color temperature
- Purpose : Adjust the color temperature to reduce the
deviation of the module color temperature.
- Principle : To adjust the white balance without the
saturation,
(Fix the one of R/G/B gain to C0 and decrease the others.)
5.2 Adjustment mode : Two modes of Cool and Warm
(Medium data is automatically calibrated by the
Cool data)
O Required Equipments
- Remote controller for adjustment
- Color Analyzer : CA100+ or CA-210 or same product
- Remote controller for adjustment
- Color Analyzer : CA100+ or CA-210 or same product
LCD TV(ch : 9)
- Auto W/B adjustment instrument(only for Auto adjustment)
5.3 Connecting diagram of equipment for
measuring (For Automatic Adjustment)
(1) Enter the adjustment mode of DDC
- Set command delay time : 50ms
- Enter the DDC adjustment mode at the same time heat-
- Enter the DDC adjustment mode at the same time heat-
run mode when pushing the power on by power only
key.
key.
- Maintain the DDC adjustment mode with same condition
of Heat-run
-> Maintain after AC off/on in status of Heat-run pattern
display)
(2) Release the DDC adjustment mode
- Release the adjust mode after AC off/on or std-by off/on
in status of finishing the Hear-run mode
- Release the Adjust mode when receiving the aging off
command(F3 00 00) from adjustment equipment
- Need to transmit the aging off command to TV set after
finishing the adjustment.
- Check DDC adjust mode release by exit key and
release DDC adjust mode
(3) Enter the adjust mode of white balance
- Enter the white balance adjustment mode with aging
command(F3, 00, FF)
* Luminance min value is 200cd/ß≥ in the cool mode(For
LCD)
6. Adjustment of White Balance for
Manual adjustment
• Adjustment mode : Two modes (Cool and Warm)
(Medium data is automatically calibrated by the Cool data)
• Color analyzer(CA100+, CA210) should be used in the
(Medium data is automatically calibrated by the Cool data)
• Color analyzer(CA100+, CA210) should be used in the
calibrated ch by CS-1000
(LCD : CH9, PDP : CH10)
• Operate the zero-calibration of the CA100+ or CA-210, then
stick sensor to the module when adjusting.
• For manual adjustment, it is also possible by the following
sequence.
1) Select white pattern of heat-run by pressing "POWER ON"
key on remote control for adjustment then operate heat run
longer than 15 minutes.
longer than 15 minutes.
(If not executed this step, the condition for W/B may be
different.)
different.)
2) Push "Exit" key.
3) Change to the AV mode by remote control.(Push front-AV
3) Change to the AV mode by remote control.(Push front-AV
or Input key)
4) Input external pattern(85% white pattern)
5) Push the ADJ key two times (entering White Balance
5) Push the ADJ key two times (entering White Balance
mode)
6) Stick the sensor to the center of the screen and select
each items (Red/Green/Blue Gain and Offset) using
D
/
E
(CH +/-) key on R/C..
7) Adjust R/ G/ B Gain using
F
/
G
(VOL+/-) key on R/C.
8) Adjust two modes (Cool and Warm)
(Fix the one of R/G/B and change the others)
9) When adjustment is completed, Exit adjustment mode
using EXIT key on R/C.
- 13 -
Click on the first or last page to see other 42LG70YR (CHASSIS:LP81D) service manuals if exist.