42LG700H (CHASSIS:LA86A) - LG TV Service Manual (repair manual). Page 9

- 9 -

This specification sheet is applied for all of the LCD TV with
LA80A chassis.

(1) Because this is not a hot chassis, it is not necessary to use

an isolation transformer. However, the use of isolation
transformer will help protect test instrument.

(2) Adjustment must be done in the correct order.
(3) The adjustment must be performed in the circumstance of

25±5°C of temperature and 65±10% of relative humidity if
there is no specific designation.

(4) The input voltage of the receiver must keep 100~120V,

50/60Hz.

(5) The receiver must be operated for about 5 minutes prior to

the adjustment.

* After RGB Full White in HEAT-RUN Mode, the receiver

must be operated prior to the adjustment.

* Enter into HEAT-RUN MODE

1) Press the POWER ON KEY on R/C for adjustment.
2) OSD display and screen display 100% full WHITE
PATTERN.

* Set is activated HEAT run without signal generator in this

mode. 

* Single color pattern (RED / BLUE / GREEN) of HEAT

RUN MODE uses to check panel. 

* Caution: If you turn on a still screen more than 20

minutes (Especially digital pattern, cross hatch pattern :
13CH), an after image may be occur in the black level
part of the screen.

(1) Connect port(3) with Power Code 
(2) Connect jack(1) with PTC Micom.
(3) Connect USB Cable to the computer 
(4) Download Program execution (SAP Configuration) 

* Notice!

Because PTC Download JIG has internal memory, it can
save download files using download program (SAP
Configuration). Push the START button (4) after file saving,
then it execute download. 

(SAP Configuration)

(1) Select HCS12
(2) Target Frequency Settings : 

1) Checking the factor -> Use Specified Target

Frequency…, Unsecure target….

2) Insert Target Bus Frequency -> 7372800

(3) Specify Algorithm: 9S12dt128_128k .12P
(4) Specify S Record: select download file. 
(5) Checking factor: Erase Device, Blank Check Device,

Program Device, Verify Device 

* Notice!

Don’t check other checking boxes. You must follow fig.

(6) Push the ‘Save Image to Cyclone PRO’ button, files

transfer from PC to the Download JIG.

4. Start button

3. Power

1. Connect to Micom port of TV board.

2. Connect to computer.

3

4

 

1

2

5

6