37LH40, 37LH41 (CHASSIS:LA92G) - LG TV Service Manual (repair manual). Page 18

5.5 EYE-Q function check

Step 1) Turn on TV
Step 2) Press EYE key of Adj. R/C
Step 3) Cover the Eye Q II sensor on the front of the using

your hand and wait for 6 seconds

Step 4) Confirm that R/G/B value is lower than 10 of the

“Raw Data (R: G: B: )” .

If after 6 seconds, R/G/B value is not lower than 10,
replace Eye Q II sensor

Step 5) Remove your hand from the Eye Q II sensor and wait

for 6 seconds

Step 6) Confirm that “B. Light(xxx)” value increases from 0.

If change is not seen, replace Eye Q II sensor

< step 2>                       < step 3>                       < step 4>

< step 5>                    < step 6>

5.7 Ship-out (Default) mode check (Instop)
• After final inspection, press In-Stop key of the Adjustment R/C

and check that the unit goes to Stand-by mode.

• After final inspection, Mechanical S/W(AC S/W) to the “on”

position.

- Check that Power Cord is fully inserted to the set

(If loose, re-insert)

- Unit w/ fully inserted power cord and A/V arrives to the auto-

check process.

- Connect D-terminal AV JACK TESTER
- Auto CONTROLLER(GWS103-4) ON
- Perform GND TEST
- If NG, Buzzer will sound to inform the operator
- If OK, changeover to I/P check automatically

(Remove CORD,A/V from AV Jack Box)

- Perform I/P test
- If NG, Buzzer will sound to inform the operator
- If OK, Good lamp will lit up and the stopper will allow the

pallet to move on to next process.

6.2 Checkpoint

NEUTRAL

• LEAKAGE CURRENT: At 0.5mArms

7.1 Overview

•USB download allows fast SW upgrade in SVC areas or

during Board-level production

7.2 Download Method

1) After set on, confirm that image is displayed
2) Insert USB memory stick that contains the SW and after

few seconds similar image to the picture below will appear

3) In [Current TV Software Version Information] confirm

current version, and in [New Found TV Software Version
Information] confirm to-be version then press Enter by
selecting Start

4) Progress bar will appear as below and after completion,

the set will reset (if the process does not advance to the
picture below, reset the unit and repeat the steps)

5) After download is complete, remove USB memory stick
6) By pressing In-Start on the adj. R/C, check the version

- 18 -

C

2009

TV Software Upgrade

INFORMATION

MODEL

Current ver.

Update ver.

LU-FHD 128

Ver. 3.00

Ver. 3.01

47LH40-UA-v0301.epk

START

CANCEL

Press arrow key to move to the Start and....

TV Software Upgrade

Do not unplug until restart automatically

UPGRADING....

25%

TV Software Upgrade

Do not unplug until restart automatically

UPGRADING....

COMPLETE