37LB5RTC (CHASSIS:LP7BA) - LG TV Service Manual (repair manual). Page 13

- 13 -

* Caution : Before White-balance, the AV ADC should be done.

=> Notice

- Do the white balance adjustment under the 10LUX
- Before white balance, press the In-start key 2times and do

the reset like Fig.5

- Use the Torino inner pattern(216 gray pattern)  
- To enter White-balance mode,press the IN-START key

2times. 

* Caution : - System control RS-232 Host should be "PC" for

adjustment.

(Fig. 4)

* Test Equipment

LCD : Color Analyzer ( CA-110), PDP : Color Analyzer (CA-

100)

CA-210 : The both of LCD and PDP are available.
PC (for communication through RS-232C) -> UART Baud
rate : 115200
Pattern Generator (MSPG-925FA etc. )

* Color Temperature & Color Coordinates Setting

When adjusting the Color Temperature of LCD, Color
AnalyzerCA-210(Matrix should be corrected through CH9 of
CS-1000) should be used.
When adjusting the Color Temperature of PDP, Color
AnalyzerCA-210(Matrix should be corrected through CH10
of CS-1000) should be used.
Adjust the Color Temperature based below adjustment color
coordinates.
Even if CH9 of CA-210 is corrected with Matrix, there may
be many character of Module and Filter.
Therefore Refer to the below Color Coordinates Target.
But, in case of WCG module, use the CH12 of CA-210. 

White Balance(Hex)

Color  Temp.       

Cool

Red    Gain.        

80

Green  Gain. 

80

Blue   Gain.         

80

Red    Offset        

80

Green  Offset        

80

Blue   Offset        

80

Reset 

_ To set