Read LG 32LW470S (CHASSIS:LD12P) Service Manual online
- 15 -
4.3. Wireless function check
Step 1) Connect set and Dongle of Wireless to Cable of HDMI
& TTA 20Pin.
Step 2) At OSD of SET, check the message like Fig.3.
Step 3) Detach Cable of Wireless Dongle.
Step 3) Detach Cable of Wireless Dongle.
4.4. EYE-Q function check
Step 1) Turn on TV.
Step 2) Press EYE key of Adjustment remote control.
Step 3) Cover the Eye Q II sensor on the front of the using
Step 2) Press EYE key of Adjustment remote control.
Step 3) Cover the Eye Q II sensor on the front of the using
your hand and wait for 6 seconds.
Step 4) Confirm that R/G/B value is lower than 10 of the “Raw
Data (Sensor data, Back light)”. If after 6 seconds,
R/G/B value is not lower than 10, replace Eye Q II
sensor.
R/G/B value is not lower than 10, replace Eye Q II
sensor.
Step 5) Remove your hand from the Eye Q II sensor and wait
for 6 seconds.
Step 6) Confirm that “ok” pop up. If change is not seen,
replace Eye Q II sensor.
4.5. 3D function test
4.5.1. HDMI 3D
(Pattern Generator MSHG-600, MSPG-6100 [Support HDMI 1.4])
* HDMI mode No. 872, pattern No. 83)
1) Please input 3D test pattern like below
* HDMI mode No. 872, pattern No. 83)
1) Please input 3D test pattern like below
2) When 3D OSD appear automatically, then select green key.
3) Don’t wear a 3D Glasses, Check the picture like below.
4.5.2. RF emitter inspection
(1) Start 3D pattern inspection
(2) If RF emitter signal is correctly received to RF receiver, the
lamp of RF tester turn on.
Fig . 1
< Do ng le>
Fig . 3 Connect the Dongle
( Do ng le Co nnec t io n Disp lay)
Fig . 2
< Wireless Read y Set >
Connect
<IR Tester Lamp turned off(NG)>
<IR Emitter inspection>
<IR Tester Lamp turned on(OK)>
Click on the first or last page to see other 32LW470S (CHASSIS:LD12P) service manuals if exist.