32LG40 (CHASSIS:LA89D) - LG TV Service Manual (repair manual). Page 14

- 14 -

(1) Brightness : Full white 216 Gray 
(2) Standard color coordinate and white balance when using

the CS-1000

(3) Standard color coordinate and white balance when using

the CA-210 (CH 10)

- Set write size to 64 bytes
- Set delay time to 250ms
- Connect D-sub Signal Cable to D-Sub Jack
- Input HDCP key with HDCP-key- in-program
- HDCP Key value is stored on EEPROM(AT24C512) which is

80~A1 addresses of  0xA0~0xA2 page

- AC off/ on and on HDCP button of MSPG925 and confirm

whether picture is displayed or not of using MSPG925

- HDCP Key value is different among the sets. 

model only, which selects the rating related country.

2) Applied models: LA89D Chassis applied None USA

Model(Canada, Mexico)

1) Press the In-Start key of the R/C and press the red oval

OP1(PIP CH-) key to enter into the Factory Option menu.

2) Select 1.USA, 2.CANADA or 3.MEXICO from the country

select according to the destination. At this time, use the
volume +/- key to adjust 

- After completing the final test, in order to set the set to the

shipping condition, press the In-Stop key of the R/C to make
sure that the set is turned off.

(1) Preparing for the automatic test on the GND & resisting

pressure 

- Make sure that the power cord is inserted into the set

completely. (When it is disconnected or loosened, test
after inserting it)

(2) Perform the automatic test on the GND & resisting pressure

1) The set with power cord, the cord and the A/V

completely inserted into the tuner is loaded on the pallet
and entered into the automatic test process.

2) Connect the D-terminal AV JACK tester
3) Turn on the automatic (GWS103-4)
4) Perform the GND TEST
5) If it is not good, the buzzer is operated to notify the test

result to the operator.

6) If it is OK, it is automatically switched to the resisting

pressure test. (Disconnect the cord and the A/V from the
AV JACK BOX)

6) Perform the resisting pressure test
7) If it is not good, the buzzer is operated to notify the test

result to the operator.

8) If it is OK, the GOOD LAMP is turned and the stopper is

moves down, and it moves to the next process.

(1) TEST voltage

- GND : 1.5KV/min at 100mA
- SIGNAL : 3KV/min at 100mA

(2) TEST time:1 second
(3) TEST POINT

- GND test = between Power cord GND and Signal cable

metal GND

- Resisting pressure test = between Power cord GND and

Live & Neutral

(4) LEAKAGE CURRENT: Set to 0.5mArms 

Mode

Color Coordination

Temp

∆UV

x

y

COOL

0.276

0.283

11000K

0.0000

MEDIUM

0.285

0.293

9300K

0.0000

WARM

0.313

0.324

6500K

0.0000

Mode

Color Coordination

Temp

∆UV

x

y

COOL

0.276±0.002

0.283±0.002

11000K

0.0000

MEDIUM

0.285±0.002

0.293±0.002

9300K

0.0000

WARM

0.313+0.002

0.324±0.002

6500K

0.0000