32LB75, 32LB76 (CHASSIS:LD73C) - LG TV Service Manual (repair manual). Page 12

1) Adjust in the place where the influx of light like floodlight

around is blocked. (illumination is less than 10Lux).

2) Adhere closely  the Color Analyzer (CA-210) to the module

less than 10cm distance, keep it with the surface of the
Module and Color Analyzer’s Prove vertically. (80~100°).

3) Aging time  

- After aging start, keep the power on (no suspension of

power supply) and heat-run over 15 minutes.

- Using ‘no signal’ or ‘full white pattern’ or the others,

check the back light on.

(Set:RS-232C, Host:PC, Baud Rate:115200bps, Download:Cortez)

Inside pattern is used when white balance is controlled.
Connect as below figure and click the start button on W/B
execution program. W/B is automatically processing Cool ->
Medium -> Warm in order. 
When W/B is completed, you can see ‘OK’ on PC monitor.

- One of R Gain / G Gain / B Gain should be kept on 80, and

others  are controlled lowering from 80 

(1) Press ‘power on’ of the control R/C, set heat run to white

by pressing 

G

, and heat run over 15 minutes. (Set : RS-233

Host : PC, Baud Rate : 115200bps, Download : Cortez)

(2) Zero Calibrate CA-210, and when controlling, stick the

sensor to the center of LCD module surface.

(3) Double click In-start key on Controlling R/C and get in

‘white balance’.

(4) Set test-pattern on and display inside pattern. Control is

carried out on three color temperature, COOL, MEDIUM,
WARM. (Control is carried out three times,)

5) When the R/G/B GAIN is 80 on OSD, it is the FULL

DYNAMIC Range of the Module. In order to control white
balance without the saturation of FULL DYNAMIC Range
and DATA, one of R Gain / G Gain / B Gain should be kept
on 80, and other two is controlled lowering from 80.

* Color Temperature: Cool, Medium, Warm

1) When R GAIN is set to 80

- Control G GAIN and B GAIN by lowering from 80. 

2) When B GAIN is set to 80

- Control R GAIN and G GAIN by lowering from 80.

3) When G GAIN is set to 80

- Control R GAIN and B GAIN by lowering from 80.

One of R Gain / G Gain / B Gain should be kept on 80,
and adjust other two lower than 80.
(When R/G/B GAIN are all 80, it is the FULL DYNAMIC
Range of Module)

(1) Setting up like bottom figure (After setting white balance,

this is set)
1) Press ADJ Key in the Adjust remocon.
2) Select  “System Control 2” by using 

D

/

E

(CH+/-) key, and

press 

A

(ENTER).

3) Using Adjust remocon, RS-232 Host & Baud Rate &

Download value change (RS-232 Host:Gprobe, Baud
Rate:115200bps, Download:Cortez)

(2) Bar-code scanning

1) Push the menu button in DTV mode. 

Select the STATION -> Diagnostics -> To set

2) Check the Serial Number.

- 12 -