Read LG 26LV5500-CA (CHASSIS:LC01S / LC01T) Service Manual online
LG Electronics Inc. Display Division
Establish : 2010/12/06
Reform :
Reform :
LC01S Adjust specification
LG(56)C2-0789-00
12/ 21
LG electronics
4
.5.2 Manual adj. method
1) Set TV in Adj. mode using POWER ON
2) Zero Calibrate the probe of Color Analyzer, then place it on the center of LCD module within 10cm of the surface..
3) Press ADJ key Æ EZ adjust using adj. R/C Æ 7. White-Balance then press the cursor to the right (KEY ).
2) Zero Calibrate the probe of Color Analyzer, then place it on the center of LCD module within 10cm of the surface..
3) Press ADJ key Æ EZ adjust using adj. R/C Æ 7. White-Balance then press the cursor to the right (KEY ).
(When KEY( ) is pressed 216 Gray internal pattern will be displayed)
4) One of R Gain / G Gain / B Gain should be fixed at 192, and the rest will be lowered to meet the desired value.
5) Adj. is performed in COOL, MEDIUM, WARM 3 modes of color temperature.
▪ If internal pattern is not available, use RF input. In EZ Adj. menu 7.White Balance, you can select one of 2 Test-
5) Adj. is performed in COOL, MEDIUM, WARM 3 modes of color temperature.
▪ If internal pattern is not available, use RF input. In EZ Adj. menu 7.White Balance, you can select one of 2 Test-
pattern: ON, OFF. Default is inner(ON). By selecting OFF, you can adjust using RF signal in 216 Gray pattern.
▪ Adj. condition and cautionary items
1) Lighting condition in surrounding area
Surrounding lighting should be lower 10 lux. Try to isolate adj. area into dark surrounding.
2) Probe location
- PDP: Color Analyzer (CA-100, CA-100+, CA210) probe should be firmly attached to the Module
- LCD: Color Analyzer (CA-210) probe should be within 10cm and perpendicular of the module surface (80°~ 100°)
- LCD: Color Analyzer (CA-210) probe should be within 10cm and perpendicular of the module surface (80°~ 100°)
3) Aging time
- After Aging Start, Keep the Power ON status during 5 Minutes.
- In case of LCD, Back-light on should be checked using no signal or Full-white pattern.
4
.6 Reference (White Balance Adj. coordinate and color temperature)
▪ Luminance: 216 Gray
[ Color Temperature ]
▪ O/S Edge LED Module
[ Color Temperature ]
▪ O/S Edge LED Module
Coordinate
Mode
x
y
Temp
△
uv
Cool
0.276(±0.002) 0.283(±0.002)
11000K
0.0000
Medium 0.285(±0.002)
0.293(±0.002)
9300K 0.0000
Warm 0.313(±0.002)
0.329(±0.002)
6500K 0.0000
▪ 10 Point White Balance
On / Off
On / Off
Pattern Outer(default)
IRE 100
Luminance
50
Red(130.0 nit)
0
Green(130.0 nit)
0
Blue(130.0 nit)
0
※
상기의 값은 화질 Setting 후 완료될 예정
operation confirmation (Only Apply for MNT Model)
Check if Power LED Color and Power Consumption operate as standard.
■ Set Input to RGB and connect D-sub cable to set
Click on the first or last page to see other 26LV5500-CA (CHASSIS:LC01S / LC01T) service manuals if exist.