Read JBL P 80.2 (serv.man14) Service Manual online
Controls and Connections
Controls and Connections
Mounting the Amplifier
1. It allows left and right input cchannels to be
connected to the amplifier using RCA plugs
connected to the amplifier using RCA plugs
2. Speaker Output Connector - Connect speaker
wiring to these connectors. See wiring instruc-
tions on page 4 for more information.
wiring to these connectors. See wiring instruc-
tions on page 4 for more information.
3. Fuse - 20 Amp ATC type Fuse.
The JBL Power Series amplifiers can be mounted in virtually any location inside the vehicle.
However, make sure to keep the amplifier away from heater vents or ducts.
However, make sure to keep the amplifier away from heater vents or ducts.
1. At the chosen site, use the amplifier as a mounting template and mark the locations of the
four mounting holes.
four mounting holes.
2. Drill a small pilot hole at each marked location.
3. Mount the amplifier and securely tighten the mounting screws.
4. Power Connection for 12V+, GND and REM
connections for power wires. See wiring instruc-
tions on page 4 for more information.
5. Input-Level Control - Adjusts input sensitivity
for pre-amp level and speaker level inputs.
for pre-amp level and speaker level inputs.
6. electronic crossover is a 12dB/oct.
Low pass filter which can be Set at any frequency
between 32Hz and 320Hz.
Low pass filter which can be Set at any frequency
between 32Hz and 320Hz.
Multichannel Automotive Amplifier
3
P80.2
+ R - - L +
HIGH LEVEL
- L + - R +
-
-
BRIDGED
FUSE 20A
+BATT
REM
POWER
GND
+
R
INPUT
LEVEL
LEVEL
INPUT MODE
32Hz 320Hz
FREQ
ST MO
FLAT HP LP
X-OVER
4V 250mV
L
INPUTS
.
.
P80.2
1
2
3
4
1
5
8
9
6
7. It allows left and right input channels such as high level
speaker output signals to be connected to the amplifier
speaker output signals to be connected to the amplifier
8.This functions L&R channel output in speaker by
connecting L&R channel input when input mode can
be set on "ST"
if setting on "Mono", this functions L&R channel output
in speaker only by connecting R channel pass.
connecting L&R channel input when input mode can
be set on "ST"
if setting on "Mono", this functions L&R channel output
in speaker only by connecting R channel pass.
9. This switch allows these two amplifier channels to play
full range,low pass,or high pass
full range,low pass,or high pass
7
1
Click on the first or last page to see other P 80.2 (serv.man14) service manuals if exist.