Read JBL GTQ 190 (serv.man2) User Guide / Operation Manual online
15
Owner’
s Manual
Maintenance
GTQ amplifiers do not require any
regular maintenance. Periodically
checking the main power supply and
grounding points and terminal
connections is advisable. Be sure the
connections are solid and corrosion-free.
Loose or corroded connections can cause
annoying intermittent noise or unusual
operational problems. Do not allow dust
to accumulate on the amplifier heat
sinks. It will reduce the amplifier’s ability
to dissipate heat. Occasional vacuum-
cleaning will prevent dust accumulation.
regular maintenance. Periodically
checking the main power supply and
grounding points and terminal
connections is advisable. Be sure the
connections are solid and corrosion-free.
Loose or corroded connections can cause
annoying intermittent noise or unusual
operational problems. Do not allow dust
to accumulate on the amplifier heat
sinks. It will reduce the amplifier’s ability
to dissipate heat. Occasional vacuum-
cleaning will prevent dust accumulation.
Specifications
GTQ190
Power Output
30 Watts x 4 (4 Ohms, 0.05% THD)
(20Hz – 20kHz,
45 Watts x 4 (2 Ohms, 0.08% THD)
14.4V Battery Voltage)
95 Watts x 2 (Bridged 4 Ohms, 0.08% THD)
Signal-to-Noise Ratio
100dBA
Frequency Response
10Hz – 50kHz (
+
0, –1dB)
20Hz – 20kHz (
+
0, – 0.1dB)
Damping Factor
>
200
Slew Factor
>
5
Line-Level Input Sensitivity
100mV – 4V RMS
(For Rated Power)
Line-Level Input Impedance
10k Ohms
Speaker-Level Input Impedance
15 Ohm
Speaker-Level Input Sensitivity
200mV – 8V RMS
Preamp Output Level
Preamp Input:
V out = V in
Speaker Input:
V out = 1/2 V in
Minimum Speaker Impedance
Single-Ended (Non-Bridged):
Single-Ended (Non-Bridged):
2 Ohms
Bridged:
4 Ohms
Built-in Electronic
18dB per Octave Low-Pass Filter,
Crossover Frequency and Slope
Fixed Frequency: 80Hz
18dB per Octave High-Pass Filter,
Fixed Frequency: 120Hz
Fixed Frequency: 120Hz
Preamp Outputs
Fixed Full-Range Frequency Response:
10Hz – 50kHz (+0, –1dB)
10Hz – 50kHz (+0, –1dB)
Power Requirement
11 to 16V DC Negative Ground
Fuse Size
30 Amp ATC Type Fuse
Size (HxWxL)
2 x 8 x 10-7/8" (51 x 196 x 274mm)
Weight
10.2 lbs (4.62 kg)
Speaker-Level Input
Molex Mini-Fit Jr
Mating Connector
#39-01-2080
Metal Pins: 39-00-0038
Metal Pins: 39-00-0038
Declaration of Conformity
Kongevejen 194B
DK-3460 Birkerød
DENMARK
DK-3460 Birkerød
DENMARK
declare in own responsibility, that the product described
in this owner’s manual is in compliance with technical
standard:
EN 55 020/6.1988
Steen Michaelsen
Birkerød. DENMARK. 8/96
GTQ 190 - English 06/03/98 11:50 Side 15
