Read JBL DA 4002 (serv.man3) User Guide / Operation Manual online
7
Symptom
Likely Cause
Solution
No audio
Low/no remote on voltage
Check connections; turn-test turn-on voltage
Speakers are not connected
Check wiring; use VOM/DVM to measure speaker coil
or are blown
resistance
Distorted audio
Input sensitivity is not set properly
See Setting Input Sensitivity on page 5
Audio lacks “punch”
Speakers are wired with
Check polarity of connections; refer to Applications
wrong polarity
Audio cycles off and on;
A protection circuit is turning
Verify the following: off electrical system is between
amber protection LED
amplifier off and on
5 ~ 18 Vdc; temperature is not over 194°F (90°C);
(JBL badge on top panel)
no short circuits; speaker loads are not less than 2 ohms
is not lit
(4 ohms in mono)
Audio cycles off and on;
GAIN is set too high
Set Input Sensitivity correctly (see page 5)
amber protection LED
(JBL badge on top panel) is not lit
(JBL badge on top panel) is not lit
Fuse blows
Incorrect wiring or
Check connections; refer to Applications
short circuit
Declaration of Conformity
Kongevejen 194B
DK-3460 Birkerød
DENMARK
DK-3460 Birkerød
DENMARK
declare in own responsibility, that the products
described
in this owner’s manual are in compliance with technical
standard:
EN 55 020/6.1988
Steen Michaelsen
Birkerød. DENMARK. 3/98
Troubleshooting
Use the following guide to identify
symptoms and solve problems. Make
sure the vehicle’s electrical system is
working properly and power is reaching
the amplifier’s power connector.
symptoms and solve problems. Make
sure the vehicle’s electrical system is
working properly and power is reaching
the amplifier’s power connector.
DA OM 7/14/98 11:38 AM Page 7
Click on the first or last page to see other DA 4002 (serv.man3) service manuals if exist.