BPX 2200.1 - JBL Car Audio Service Manual (repair manual). Page 4

Controls and Connections

Mounting the Amplifier

The JBL BP Series amplifiers can be mounted in virtually any location inside the vehicle.
However, make sure to keep the amplifier away from heater vents or ducts.

1. At the chosen site, use the amplifier as a mounting template and mark the locations of the 
    four mounting holes.

2. Drill a small pilot hole at each marked location.

3. Mount the amplifier and securely tighten the mounting screws.

3

Power  Amplifier

BPX2200.1

Controls and Connections

3. Preamp-Level Input Connector - Connects to 

4. Pre amp-Level AUX output Connector 

    line-level output from the source unit.

2. Speaker Output Connector - Connect speaker
    wiring to these connectors. See wiring instruc-
    tions on page 4 for more information.

1. Power Connection for 12V+, GND and REM 

    connections for power wires. See wiring instruc-

    tions on page 4 for more information.

5. Input-Level Control - Adjusts input sensitivity

6. This switch is select X-over slope

    for pre-amp level and speaker level inputs.

9. The crossover frequency can be set at any frequency

10. (1) The HP frequency can be set at any frequency

     (2) Bass Boost control will provide at frequency

      Between 32Hz and 320Hz.

           Between 20Hz and 100Hz.

       Being set between 20Hz ~ 100Hz

8.

7. This switch is set to 2-channel mode(2CH/BR) to drive
    a pair of subwoofers or bridge(mono) mode to drive a 
    single subwoofer(PARALLEL). 
    It's allowed to use parallel mode when the nominal
    impedance of the speaker system is 2 ohm or greater

1

2

3

4

5

7

8

6

Remotr Volume Control Jack.

9

10