Read JBL BP 150.1 (serv.man2) Service Manual online
Controls and Connections
Controls and Connections
Mounting the Amplifier
1. It allows left and right input channels to be
connected to the amplifier using RC plugs.
3. Fuse - One 20 Amp ATC type Fuse.
2. Speaker Output Connector - Connect speaker
wiring to these connectors. See wiring instruc-
tions on page 4 for more information.
The JBL BP Series amplifiers can be mounted in virtually any location inside the vehicle.
However, make sure to keep the amplifier away from heater vents or ducts.
However, make sure to keep the amplifier away from heater vents or ducts.
1. At the chosen site, use the amplifier as a mounting template and mark the locations of the
four mounting holes.
four mounting holes.
2. Drill a small pilot hole at each marked location.
3. Mount the amplifier and securely tighten the mounting screws.
4. Power Connection for 12V+, GND and REM
connections for power wires. See wiring instruc-
tions on page 4 for more information.
5. Input-Level Control - Adjusts input sensitivity
for pre-amp level and speaker level inputs.
6. The electronic crossover is a 12dB/oct.
Low pass filter which can be Set at any frequency
between 32Hz and 320Hz.
7. The bass boost control will provide up to 6dB of boost
at 50Hz.
8. It allows left and right input channels such as high
level speaker output signal to be the amplifier.
1 Channel Automotive Amplifier
3
BP-150.1
+ R - - L +
+ R - - L +
HIGH LEVEL
R
R
L
L
HIGH LEVEL
INPUT
LEVEL
LEVEL
4V 250mV
32Hz 320Hz
0dB +6dB
LPF
FREQ
FREQ
BASS
BOOST
BOOST
FRONT INPUTS
REAR INPUTS
.
.
.
.
.
.
BP150.1
SPEAKER OUTPUTS
+BATT
REM
GND
POWER
FUSE 20A
- + - +
5
3
2
4
6
7
8
1
Click on the first or last page to see other BP 150.1 (serv.man2) service manuals if exist.