Read JBL A302GTi (serv.man3) Service Manual online
Controls and Connections
Controls and Connections
Mounting the Amplifier
2. Speaker Output Connector - Connect speaker
wiring to these connectors. See wiring instruc-
tions on page 4 for more information.
3. Fuse - Three 20 Amp ATC type Fuses.
The JBL GTI Series amplifiers can be mounted in virtually any location inside the vehicle.
However, make sure to keep the amplifier away from heater vents or ducts.
However, make sure to keep the amplifier away from heater vents or ducts.
1. At the chosen site, use the amplifier as a mounting template and mark the locations of the
four mounting holes.
four mounting holes.
2. Drill a small pilot hole at each marked location.
3. Mount the amplifier and securely tighten the mounting screws.
4. Power Connection for 12V+, GND and REM
connections for power wires. See wiring instruc-
tions on page 4 for more information.
5. Input-Level Control - Adjusts input sensitivity
for pre-amp level and speaker level inputs.
6. The electronic crossover is a 24dB/oct.
Low pass filter which can be Set at any frequency
between 40Hz and 400Hz.
7. The electronic crossover is a 24dB/oct.
High pass filter which can be Set at any frequency
between 40Hz and 400Hz.
8. Stereo and bridged selector switch.
9. Crossover selector switch-Low pass filter (LPF),
High pass filter (HPF) or it may be defeated (FLAT).
10. External Capacitor(Optional)
2 Channel Automotive Amplifier
3
A302GTI
SPEAKER OUTPUTS
FUSE 20Ax3
+BATT
+BATT
REM
POWER
CAPTAP
GND
GND
- + - +
X-OVER FREQUENCY
R
L
INPUT
LEVEL
LEVEL
4V 250mV
40Hz 400Hz
40Hz 400Hz
HPF
FREQ
FREQ
LPF
FREQ
FREQ
.
.
.
.
.
.
A302GTI
7
9
8
2
3
10
4
5
1
6
ST BR
HPF FLAT LPF
REMOTE
1. Preamp-Level Input Connector - Connects to
line-level output from the source unit.
line-level output from the source unit.
Click on the first or last page to see other A302GTi (serv.man3) service manuals if exist.