600 GTi - JBL Car Audio User Guide / Operation Manual. Page 6

Mounting the Speaker
1.

Use the grill included in the package to
mark the location of the four screw
holes and the speaker cutout holes
(cutout hole size listed in Specifications
section). Before cutting or drilling make
sure that there are no car components,
electrical wiring or any other items that
could be damaged.

2.

Cut out the speaker hole at the
mounting location and drill the four
marked holes with a 

1

/

8

" (3mm) drill.

3.

Run speaker wire to the hole location,
making sure that either an active or
passive crossover is connected to the
speaker.

4.

Connect the speaker wire to the
speaker by either soldering (preferred)
or using crimp terminals. The 600GTi
uses a .205 flat blade terminal for the +
connection and a .110 terminal for the –
connection.

5.

Mount the speaker to the hole location
using four #8 x 1

1

/

4

" screws as shown in

Figure A.

6.

Push the metal grille down onto the
grille frame, making sure to align the
logo as desired.

Note: The metal grille is designed so

that it can be covered with grille cloth if de-
sired. Simply remove the metal grille from
the grille frame as shown in Figure A. Then
use spray adhesive to glue and wrap the
grille cloth to the metal grille. Push the
metal grille with cloth back in the grille
frame. For even better interior matching it
is also possible to use plastic compatible
paint to match the grille frame to the vehi-
cle’s interior color.

6

Figure A

600 MANUAL/vs2.QXP  7/28/98 11:47 AM  Page 6