504 GTi - JBL Car Audio User Guide / Operation Manual. Page 8

Read JBL 504 GTi User Guide / Operation Manual online

4.
Connect the speaker wire from the
crossover terminals marked “T” to the
tweeter terminals of the speaker by
either soldering (preferred) or using
crimp terminals. The “+T ” terminal of
the crossover should be connected to
the orange colored T terminal on the
speaker.
5.
The Intermount
TM
adapter plate has a
series of mounting holes which allow
the coupled component tweeter to be
angled as desired. Pick an orientation
which angles the tweeter in the
desired direction and mount the
woofer/midrange driver to the
Intermount
TM
adapter ring using three
#8 x 
7
/
16
" screws as shown in Figure C.
6.
Replace the stock speaker panels.
Mounting Speakers in Custom
Locations
1.
Snap the grill of the speaker onto the
driver and choose three hole locations
so that the tweeter is angled properly
and the grille logo is oriented as desired
for your installation. Use the Fabric
Displacement Ring included in the
package to mark the location of the
three screw holes and the speaker
cutout holes (cutout hole sizes are
listed in Specifications section). Before
cutting or drilling make sure that there
are no car components, electrical wiring
or any other items that could be
damaged.
2.
Cut out the speaker hole at the
mounting location and drill the three
marked pilot holes with a 
1
/
8
" (3mm) drill.
3.
Run speaker wire to the hole location,
making sure that either an active or
the included passive crossover is
connected before the speaker. 
4.
Put the speaker Fabric Displacement
Ring under the speaker as shown in
Figure D.
8
Figure C
INTERMOUNT
ADAPTOR
PLATE
404/504 MANUAL.QXP  7/17/98 11:39 AM  Page 8
Page of 16
Display

Click on the first or last page to see other 504 GTi service manuals if exist.