Read JBL STUDIO 180 Service Manual online
Release Date 2010 Discontinued Date XXXX
Technical Manual
STUDIO 180
AURAL-SWEEP TEST SPECIFICATIONS:
• System aural-sweep test:
• System aural-sweep test:
6.0V input 45Hz to 20kHz
• LF aural-sweep test:
5.0V input 45Hz to 1.5kHz
• MF aural-sweep test:
5.0V input 1kHz to 3kHz
• HF aural-sweep test:
2.83V input 2kHz to 20kHz
PHYSICAL SPECIFICATIONS:
• Dimensions (W x H x D):
• Dimensions (W x H x D):
7-7/8" x 40" x 13-1/8"
(200mm x 1016mm x 333mm)
• Weight:
38.6 lb (17.5kg) each
WARRANTY:
• Refer to the warranty statement packed with the product.
• Refer to the warranty statement packed with the product.
* The maximum recommended amplifier power rating will
ensure proper system headroom to allow for occasional
peaks. We do not recommend sustained operation at these
maximum power levels.
STUDIO
180
11/10
ACOUSTIC & ELECTRICAL SPECIFICATIONS:
• Nominal impedance:
8 ohms
• Maximum amplifier power: 90W continuous; 360W peak*
• Frequency response:
• Frequency response:
45Hz – 22kHz
• Sensitivity:
89dB (2.83V/1m)
• Crossover frequencies:
1.1kHz, 2.5kHz (6dB/octave)
SYSTEM COMPONENTS:
• Cabinet:
• Cabinet:
Studio 180 cabinet (not for sale)
• Top grille:
Studio 180 top grille
(244-060-5439-0BAE)
• Bottom grille:
Studio 180 bottom grille
(244-060-05440-0BAE)
• Low-frequency transducer: 6-1/2" (165mm) PolyPlas
™
cone,
shielded (16PR90BZM-FW01-E)
DC resistance:
4.5 ohms ±10%
• Mid-frequency transducer: 4" (101mm) PolyPlas cone, shielded
(10PR75AX-HW01-E)
DC resistance:
4.6 ohms ±10%
• High-frequency transducer: 1" (25mm) CMMD
®
Lite dome,
shielded (36DT25BX-DT01-E)
DC resistance:
3.6 ohms ±10%
• Crossover network:
013-7600-05822-E
STUDIO 180 WIRING DIAGRAM
Legend on Page 2
31
29
26
32
30
28
27
24
25
STUDIO 180 SCHEMATIC
PACKAGING
+
+
+
–
–
–
GREEN
LOW-FREQUENCY
TRANSDUCER
16PR90BZM-FW01-E
CROSSOVER
NETWORK
013-7600-05822-E
MIDRANGE
TRANSDUCER
10PR75AX-HW01-E
HIGH-FREQUENCY
TRANSDUCER
36DT25BX-DT01-E
BLACK
BLACK
BLACK
WHITE
RED
RED
BLACK
YELLOW
WHITE
Technical Manual
STUDIO 180
STUDIO
180
EXPLODED VIEW
HARMAN Consumer, Inc.
© 2010 HARMAN International Industries, Incorporated. All rights reserved. JBL and CMMD are trademarks of HARMAN International Industries, Incorporated,
registered in the United States and other countries. PolyPlas is a trademark of HARMAN International Industries, Incorporated.
Features, specifications and appearances are subject to change without notice.
11/10
TO SERVICE THE STUDIO 180:
Woofer:
Woofer:
Remove the lower grille. Remove the six screws holding the woofer using a 2.5mm hex key (Allen wrench). If the woofer will not come out of the
cabinet easily, use a dowel or hammer handle inserted into the rear port tube opening to tap the woofer out.
Tweeter, Midrange: Remove both grilles. Remove all eight grille cups in the front bezel with a needle-nosed pliers or similar tool. Remove all eight bezel screws
using a 2.5mm hex key. Remove the bezel by pulling it straight out from the cabinet.
Tweeter: Remove two Phillips screws from bar holding tweeter to bezel.
Tweeter, Midrange: Remove both grilles. Remove all eight grille cups in the front bezel with a needle-nosed pliers or similar tool. Remove all eight bezel screws
using a 2.5mm hex key. Remove the bezel by pulling it straight out from the cabinet.
Tweeter: Remove two Phillips screws from bar holding tweeter to bezel.
www.jbl.com
1
2
3
4
14
5
12
13
11
23
22
9
10
15
16
20
19
21
8
7
6
18
17
1 Not for Sale
Studio 180 Cabinet
1
(Black, Black w/Grain, Cherry)
2 317-ABS-05059-0BAE Terminal Cup
1
3 350-EM03520D082-E
Screws, Terminal Cup T3.5*20
4
4 10PR75AX-HW01-E
4" Midrange
1
5 350-KM03516D076-E
Screws, Midrange T3.5*16
4
6 16PR90BZM-FW01-E
6-1/2" Woofer
1
7 213-060-05227-0BAE
6-1/2" Trim Ring
1
8 350-KM03520D077-E
Screws, Woofer, T3.5*20
6
9 243-060-05279-0BAE
Plastic Bezel
1
10 214-036-05435-0BAE
Gasket, Tweeter
1
11 36DT25BX-DT01-E
1" Tweeter
1
12 398-ABS-05062-E
Plastic Bar, Tweeter
1
13 352-AM03512D121-E
Screws, Tweeter T3.5*12
2
14 333-EVA-06006-0BAE Gasket, Tweeter Bezel
1
15 350-KM03526D078-E
Screws, Bezel T3.5*26
8
16 327-010-05055-0BAE
Grille Cup
14
17 320-RUB-05085-0BAE Rubber Feet
4
18 357-CC25153-E
Insert Nut
4
19 316-AL-05412-0VAE
JBL
®
Logo
1
20 244-060-05439-0BAE Grille, Top
1
21 244-060-05440-0BAE Grille, Bottom
1
22 013-7600-05822-E
Crossover Network (Inside Cabinet)
1
23 Not for Sale
Port Tube
1
24 Visit www.jbl.com
Studio Series Owner’s Manual
1
25 Not for Sale
Plastic Bag
1
26 402-000-06484-E
Studio 180 Outer Carton, Cherry (CH)
1
402-000-06483-E
Studio 180 Outer Carton, Black w/grain (BK) 1
402-000-06496-E
Studio 180 Outer Carton, Black
1
27 Not for Sale
Warranty Card
1
28 431-000-07211-E
Foam, Top
1
29 431-000-07212-E
Foam, Middle
1
30 431-000-07213-E
Foam, Bottom
1
31 322-000-05017-0BAE Spike Foot Set
1
32 Not for Sale
Desiccant
2
ITEM
NO. PART NO.
DESCRIPTION
QTY.
ITEM
NO. PART NO.
DESCRIPTION
QTY.
Display