SCS 300 SAT (serv.man2) - JBL Audio User Guide / Operation Manual. Page 4

Important Safety Note: The
customer is solely responsi-
ble for proper selection of
mounting hardware not
included with the speaker,
and for proper assembly 
and installation of the wall-
bracket, including but not
limited to the selection of
appropriate weight-bearing
supports and proper use of
the bracket. JBL disclaims
any liability for the selection
of mounting hardware and/or
bracket installation. Be sure
to follow these bracket
assembly and installation
instructions carefully. If you
have any questions or doubts
about your ability to correctly
wall-mount the speakers,
consult with your authorized
JBL dealer or custom
installer.
Step 1: Unscrew and remove
the large Molded Nut ™. If
necessary, use the supplied
Metal Bar ∞ as a lever by
inserting it into one of the
holes in the outer edge of the
Molded Nut ™.

Step 2: Firmly grasp the Ball
and Shaft £ and pull it
straight out of the Attach-
ment Plate ¢. Avoid leaning
it to the side for leverage, as
this may break off a tab.

Step 3: Slide the Molded Nut
™ onto the Ball and Shaft £
with the threaded opening
facing the ball. Thread the
Metal Nut ¡ all the way
onto the Ball and Shaft £,
with the star washer side
away from the ball. Refer to
the exploded drawing for the
proper orientation of these
three parts.

Step 4: Screw the Ball and
Shaft £ into the Threaded
Insert § on the back of the
Satellite Speaker ¶ until 
it is fully seated in the
Threaded Insert §, but do
not tighten as you might dis-
lodge the Threaded Insert §.
Such damage would 
not be covered under the
warranty.

Step 5: Tighten the Metal Nut

¡

with the star washer side

between the Metal Nut

¡

and the back of the Satellite
Speaker

¶

, using large 

needle-nose pliers until it is
firmly seated against the
back of the Speaker

¶

and

has locked the Ball and Shaft

£

and the Speaker

¶

together. 
Note that once the Metal Nut
¡ is fully tightened, it may
embed some marks on the
back of the Satellite Speaker
¶. However, these marks will
be covered by the Metal Nut ¡

Step 6: Mount the Attach-
ment Plate ¢ into a wood
stud on the wall, using four
#10 pan-head wood screws
at least one inch long (not
supplied) 

•. Make sure that

all four screws are driven

into the stud and not into
drywall. If the bracket needs
to be mounted in drywall, the
customer is responsible for
selecting and using appro-
priate wall-anchors and
screws.

Important Note: The Metal
Nut

¡

must be fully tight-

ened against the Satellite
Speaker

¶

as described in

Step 5 before beginning Step

1

2

3

4

8

5

1

2

3

4

5

6

7

8