SCS 260 (serv.man3) - JBL Audio User Guide / Operation Manual. Page 7

Important Safety Note: The
customer is solely responsi-
ble for proper selection of
mounting hardware not
included with the speakers,
and for proper assembly and
installation of the wall-brack-
ets, including but not limited
to the selection of appropri-
ate weight-bearing supports
and proper use of the
bracket. JBL disclaims any
liability for the selection of
mounting hardware and/or
bracket installation. Be sure
to follow these bracket
assembly and installation
instructions carefully. If you
have any questions or
doubts about your ability to
correctly wall-mount the
speakers, consult with your
authorized JBL dealer or
custom installer.

Step 1: Unscrew and remove
the large Molded Nut

™

. If

necessary, use the supplied
Metal Bar

∞

as a lever by

inserting it into one of the
holes in the outer edge of the
Molded Nut

™

.

Step 2: Firmly grasp the Ball
and Shaft

£

and pull it

straight out of the Attach-
ment Plate

¢

. Avoid leaning

it to the side for leverage, as
this may break off a tab.

Step 3: Slide the Molded Nut

™

onto the Ball and Shaft

£

with the threaded open-

ing facing the ball. Thread
the Metal Nut ¡ all the way
onto the Ball and Shaft £,
with the star washer side
away from the ball. Refer to
the exploded drawing for the
proper orientation of these
three parts.

Step 4: Screw the Ball and
Shaft

£

into the Threaded

§

on the back of the

¶

until it

is fully seated in the
Threaded Insert

§

, but do

not tighten as you might dis-
lodge the Threaded Insert
§. Such damage would 
not be covered under the
warranty.

Step 5: Tighten the Metal Nut

¡

with the star washer side

between the Metal Nut

¡

and the back of the Satellite
Speaker

¶

, using large 

needle-nose pliers until it is
firmly seated against the
back of the Speaker

¶

and

has locked the Ball and
Shaft

£

and the Speaker

¶

together. 
Note that once the Metal
Nut

¡

is fully tightened, it

may embed some marks on
the back of the Satellite
Speaker

¶

. However, these

marks will be covered by the
Metal Nut

¡

.

Step 6: Mount the Attach-
ment Plate

¢

into a wood

stud on the wall, using four
#10 pan-head wood screws
at least one inch long (not
supplied) 

•

. Make sure that

all four screws are driven
into the stud and not into dry-
wall. If the bracket needs to
be mounted in drywall, the 
customer is responsible for
selecting and using appro-
priate wall-anchors and
screws. 

Important Note: The Metal
Nut

¡

must be fully tight-

ened against the Satellite
Speaker

¶

as described in

1

2

3

4

8

5

1

2

3

4

5

6

7

8