SCS 200 (serv.man13) - JBL Audio Service Manual (repair manual). Page 8

Important Safety Note: The
customer is solely responsi-
ble for proper selection of
mounting hardware not
included with the speakers,
and for proper assembly and
installation of the wall-brack-
ets, including but not limited
to the selection of appropri-
ate weight-bearing supports
and proper use of the
bracket. JBL disclaims any
liability for the selection of
mounting hardware and/or
bracket installation. Be sure
to follow these bracket
assembly and installation
instructions carefully. If you
have any questions or
doubts about your ability to
correctly wall-mount the
speakers, consult with your
authorized JBL dealer or
custom installer.

Step 1: Unscrew and remove
the large Molded Nut

™

. If

necessary, use the supplied
Metal Bar

∞

as a lever by

inserting it into one of the
holes in the outer edge of the
Molded Nut

™

.

Step 2: Firmly grasp the Ball
and Shaft

£

and pull it

straight out of the Attach-
ment Plate

¢

. Avoid leaning

it to the side for leverage, as
this may break off a tab.

Step 3: Slide the Molded Nut

™

onto the Ball and Shaft

£

with the threaded open-

ing facing the ball. Thread
the Metal Nut

¡

all the way

onto the Ball and Shaft

£

,

with the Metal Nut’s

¡

“knurled” surface facing
away from the ball. Refer to
the exploded drawing for the
proper orientation of these
three parts.

Step 4: Screw the Ball and
Shaft

£

into the Threaded

§

on the back of the

¶

until it

is fully seated in the
Threaded Insert

§

.

Step 5: Tighten the Metal Nut

¡

using a crescent wrench

(spanner) until it is firmly
seated against the back of
the Satellite Speaker

¶

and

has locked the Ball and

£

and the Satellite

¶

together. Note

that once the Metal Nut

¡

is

fully tightened, it may embed
some marks on the back of
the Satellite Speaker

¶

.

However, these marks will be
covered by the Metal Nut

¡

.

Step 6: Mount the Attach-
ment Plate

¢

into a wood

stud on the wall, using four
#10 pan-head wood screws
at least one inch long (not
supplied) 

•

. Make sure that

all four screws are driven
into the stud and not into dry-
wall.

Step 7: Holding the Satellite
Speaker

¶

with both hands,

reinsert the ball portion of
the Ball and Shaft

£

into the

¢

.

Step 8: Hand-tighten the
Molded Nut

™

while posi-

tioning the speaker for the
desired orientation. The
swiveling ball enables you to
aim the speaker to one side
or the other, or to tilt it up 

1

2

3

4

8

5

1

2

3

4

5

6

7

8

JBL

SCS200.5/230 Service Manual

Page 8 of 53