Read JBL PSW-D115 (serv.man2) User Guide / Operation Manual online
– 4 –
2) If your receiver/amplifier
has subwoofer outputs
or preamp output jacks
for the left, center and
right channels, or left
and right only.
or preamp output jacks
for the left, center and
right channels, or left
and right only.
If your receiver/amplifier
has a single (mono) sub-
woofer output or LFE out-
has a single (mono) sub-
woofer output or LFE out-
put, you may connect the
output to either the Left,
Right or Center line-level
input on the subwoofer.
However, to maximize the
subwoofer’s performance, we
recommend that you use a
“Y”-connector (not includ-
ed). Plug the single male
end of the “Y”-connector
output to either the Left,
Right or Center line-level
input on the subwoofer.
However, to maximize the
subwoofer’s performance, we
recommend that you use a
“Y”-connector (not includ-
ed). Plug the single male
end of the “Y”-connector
into the subwoofer output
on the receiver/amplifier,
and connect each of the
2 female connectors to an
RCA-type interconnect
cable. Then connect the 2
interconnect cables to the
Left and Right line-level
inputs on the PSW-D115.
on the receiver/amplifier,
and connect each of the
2 female connectors to an
RCA-type interconnect
cable. Then connect the 2
interconnect cables to the
Left and Right line-level
inputs on the PSW-D115.
RECEIVER/AMPLIFIER
SUBWOOFER OUT
LEFT RIGHT
MAIN SPEAKER OUTPUT
RIGHT
+ –
RIGHT
LOUDSPEAKER
LEFT
+ – – +
– +
LEFT
LOUDSPEAKER
Phase
0
180
+
+
+
+
+
+
High
Pass
60
180
120
90
150
Low
Pass
60
180
120
90
150
Off
On
Power
Direct
L
I
N
E
O
U
U
T
L
I
N
E
I
N
L
C
R
L
C
R
SPKR In
L
C
R
SPKR Out
Phase
0
180
+
+
+
+
+
+
High
Pass
60
180
120
90
150
Low
Pass
60
180
120
90
150
Off
On
Power
Direct
L
I
N
E
O
U
U
T
L
I
N
E
I
N
L
C
R
L
C
R
SPKR In
L
C
R
SPKR Out
Subwoofer
Output
RECEIVER/PREAMPLIFIER
3) If your receiver/processor
contains Dolby* Digital or
DTS® surround processing
technology, then connect
the subwoofer or LFE out-
put from your receiver/
processor to the Center
line-level input as shown.
DTS® surround processing
technology, then connect
the subwoofer or LFE out-
put from your receiver/
processor to the Center
line-level input as shown.
Set the “Low-Pass” control
to the 180Hz position.
to the 180Hz position.
When hooked up using this
method, all of the crossover
and level adjustments are con-
trolled through the receiver/
processor.
method, all of the crossover
and level adjustments are con-
trolled through the receiver/
processor.
Click on the first or last page to see other PSW-D115 (serv.man2) service manuals if exist.