Read JBL ON TOUR XTB (serv.man8) EMC - CB Certificate online
- Page 5 of 57 -
www.nemko.com
Report No. 111547
TRF No.:IECEN60950_1B
Test items particulars
Equipment mobility ..................................... :
Equipment mobility ..................................... :
Hand-held transportable equipment
Operating condition ..................................... :
Continuous
Normal load:
Normal operation is considered 1/8th of maximum
undistorted power. Non-clipping was determined using a
1 kHz sinusoidal signal input. For maximum normal
operation, 1/8th of the non-clipping amplitude was used with
a filtered pink noise input signal.
Normal load:
Normal operation is considered 1/8th of maximum
undistorted power. Non-clipping was determined using a
1 kHz sinusoidal signal input. For maximum normal
operation, 1/8th of the non-clipping amplitude was used with
a filtered pink noise input signal.
Mains supply tolerance (%)......................... :
Class III equipment.
Tested for IT power systems ...................... :
Class III equipment.
IT testing, phase-phase voltage (V) :
Class III equipment.
Class of equipment ..................................... :
Class III
Mass of equipment (kg)............................... :
0.6kg
Dimensions: 165mm in Diameter, 41mm in Height
Dimensions: 165mm in Diameter, 41mm in Height
Protection against ingress of water ............ :
N/A
Test case verdicts
Test case does not apply to the test object : N/A
Test item does meet the requirement ........ : P(ass)
Test item does not meet the requirement .. : F(ail)
Testing
Date of receipt of test item ......................... :
August – 2008
Date(s) of performance of test ................... :
August – 2008
General remarks
”This report is not valid as a CB Test Report unless appended by an approved CB Testing
Laboratory and appended to a CB Test Certificate issued by an NCB in accordance with IECEE 02”.
Laboratory and appended to a CB Test Certificate issued by an NCB in accordance with IECEE 02”.
The test result presented in this report relate only to the object(s) tested.
This report shall not be reproduced, except in full, without the written approval of the Issuing testing
laboratory.
This report shall not be reproduced, except in full, without the written approval of the Issuing testing
laboratory.
”(see attachment #)" refers to additional information appended to the report.
"(see appended table)" refers to a table appended to the report.
"(see appended table)" refers to a table appended to the report.
Throughout this report a comma (point) is used as the decimal separator.
Click on the first or last page to see other ON TOUR XTB (serv.man8) service manuals if exist.