Read JBL ON STAGEII (serv.man18) EMC - CB Certificate online
IEC 60950-1 1st. Ed, 2001
- Page 2 of 6 -
Order No. 46974
3.2.5.1
Modify Table 3B as follows:
Delete the first four rows and replace with
Delete the first four rows and replace with
Considered. N/A
Table 3B - Sizes of conductors
RATED CURRENT OF EQUIPMENT
A
Minimum conductor sizes
Nominal
cross-sectional area
mm2
AWG or kcmil
[cross-sectional area in mm2]
see note 2
Over 0.2 up to and including 3
Over 3 up to and including 7.5
Over 7.5 up to and including 10
Over 10 up to and including 16
Over 3 up to and including 7.5
Over 7.5 up to and including 10
Over 10 up to and including 16
0,5
1)
0,75
(0,75)
(0,75)
2)
1,00
(1,0 )
3)
1,5
18 [0,8]
16 [1,3]
16 [1,3]
14 [2]
16 [1,3]
16 [1,3]
14 [2]
Replace footnote 1) with the following:
1)
This nominal cross-sectional area is only allowed for Class II appliances if the length of the power supply
cord, measured between the point where the cord, or cord guard, enters the appliance, and the entry to
the plug does not exceed 2 m (0.5 mm
the plug does not exceed 2 m (0.5 mm
2
three-core supply flexible cords are not permitted; see AS/NZS
3191).
Delete Note 1.
4.3.6
Delete Note 1.
4.3.6
Replace paragraph three with:
Equipment with a plug portion, suitable for
insertion into a 10 A 3-pin flat-pin socket-outlet
complying with AS/NZS 3112, shall comply
with the requirements in AS/NZS 3112 for
equipment with integral pins for insertion into
socket-outlets.
Equipment with a plug portion, suitable for
insertion into a 10 A 3-pin flat-pin socket-outlet
complying with AS/NZS 3112, shall comply
with the requirements in AS/NZS 3112 for
equipment with integral pins for insertion into
socket-outlets.
Not direct plug-in equipment.
N/A
4.3.13.5
Add the following to the end of the first
paragraph:
‘, or AS/NZS 2211.1’.
paragraph:
‘, or AS/NZS 2211.1’.
No laser components, LEDs are
diffuse type.
diffuse type.
N/A
4.7
Add the following paragraph:
For alternative tests refer to Clause 4.7.201.
For alternative tests refer to Clause 4.7.201.
Class III equipment.
N/A
Click on the first or last page to see other ON STAGEII (serv.man18) service manuals if exist.