Read JBL ON STAGEII (serv.man12) EMC - CB Certificate online
- Page 5 of 52 -
www.nemko.com
Report No. 46974
TRF No.:IECEN60950_1B
Test items particulars
Equipment mobility ..................................... : Moveable Equipment intended for tabletop use.
Operating condition ..................................... : continuous operation
Equipment mobility ..................................... : Moveable Equipment intended for tabletop use.
Operating condition ..................................... : continuous operation
Normal load:
Max. Undistorted with sign wave signal was 16.1 W, reduced
to 1/8
to 1/8
th
Max. And switched to filtered pink noise per IEC/EN
60065 for maximum normal load.
Refer to Summary of Testing.
Refer to Summary of Testing.
Mains supply tolerance (%)......................... : N/A
Tested for IT power systems ...................... : No
IT testing, phase-phase voltage (V) :
Tested for IT power systems ...................... : No
IT testing, phase-phase voltage (V) :
N/A
Class of equipment ..................................... : Class III
Mass of equipment (kg)............................... : 0.5 kg
Mass of equipment (kg)............................... : 0.5 kg
Dimensions: 171.0 mm diameter 38 mm tall
Protection against ingress of water ............ : IP 20 (not evaluated for ingress of water)
Test case verdicts
Test case verdicts
Test case does not apply to the test object : N/A
Test item does meet the requirement ........ : P(ass)
Test item does not meet the requirement .. : F(ail)
No verdict considered necessary …………..: —
Testing
Date of receipt of test item ......................... : 2005-06-29
Date(s) of performance of test ................... : 2005-07-01 to 2005-07-05
General remarks
”This report is not valid as a CB Test Report unless appended by an approved CB Testing
Laboratory and appended to a CB Test Certificate issued by an NCB in accordance with IECEE 02”.
Laboratory and appended to a CB Test Certificate issued by an NCB in accordance with IECEE 02”.
The test result presented in this report relate only to the object(s) tested.
This report shall not be reproduced, except in full, without the written approval of the Issuing testing
laboratory.
This report shall not be reproduced, except in full, without the written approval of the Issuing testing
laboratory.
”(see attachment #)" refers to additional information appended to the report.
"(see appended table)" refers to a table appended to the report.
"(see appended table)" refers to a table appended to the report.
Throughout this report a comma (point) is used as the decimal separator.
Click on the first or last page to see other ON STAGEII (serv.man12) service manuals if exist.