ON STAGE (serv.man7) - JBL Audio User Guide / Operation Manual. Page 2

Read JBL ON STAGE (serv.man7) User Guide / Operation Manual online

Cycle 1
150 lpi
5-06-04 on stage_set-up_guide_12.qxp
K
TRIM
FOLD
TRIM
on stage 
Instrucciones de seguridad 
Sírvase leer las siguientes instrucciones de operación antes de usar
el producto
Lea las instrucciones – Es importante que lea completamente
todas las instrucciones de seguridad y operación antes de usar
este sistema de audio.
Guarde las instrucciones para su futura referencia.
Observe las advertencias – Es importante que observe todas las
advertencias en este sistema de audio y en las instrucciones de
operación.
Siga las instrucciones – Siga todas las instrucciones de operación
y uso.
PARA EVITAR EL RIESGO DE CHOQUES ELÉCTRICOS, NO RETIRE
LA TAPA (O PANEL TRASERO). NO HAY PIEZAS SUSCEPTIBLES
DE REPARACIÓN EN EL INTERIOR DE ESTA UNIDAD. TODO EL
SERVICIO DE MANTENIMIENTO DEBE SER EFECTUADO POR EL
PERSONAL DE SERVICIO CALIFICADO DE JBL.
No exponga los altavoces a líquidos ni solventes.
No retire nunca las tapas de rejilla para tratar de reparar el sistema
de altavoces. El sistema de altavoces no contiene ninguna pieza
que pueda ser reparada por el usuario. Dirija todas sus preguntas
de servicio al Grupo de Apoyo técnico de JBL.
No exponga el sistema de altavoces a temperaturas o humedad
extremas, luz solar directa, polvo excesivo o vibraciones.
Coloque el sistema de altavoces sobre una superficie estable y
nivelada. No lo deje caer ni aplique fuerza excesiva a los controles,
como tampoco ponga objetos pesados sobre ningún altavoz.
Si requiere limpieza, use un paño suave y seco. Si es necesario,
humedézcalo con agua, pero no use ningún solvente.
Para proteger el sistema de altavoces, evite la retroalimentación
del micrófono, la salida continua de instrumentos musicales elec-
trónicos  o la salida distorsionada de cualquier fuente de señales.
No coloque los altavoces cerca de luces fluorescentes o de neón.
Aunque los altavoces están protegidos magnéticamente, mantenga
los medios de almacenamiento magnético (tales como discos y
cintas) a una distancia de por lo menos diez centímetros del sistema
de altavoces para impedir la pérdida de datos.
ADVERTENCIA: para reducir el riesgo de incendio o choque eléctri-
co, no exponga este sistema de altavoces a la lluvia o humedad.
UTILICE SOLAMENTE las fuentes de alimentación JBL aprobadas y
enumeradas en la etiqueta del producto.
on stage
Safety Instructions
Please Read the Following Operation Precautions Before Use
Read instructions – All safety and operating instructions should be
read thoroughly before attempting to operate this audio system.
Retain instructions for future reference.
Heed warnings – All warnings on this audio system and in the
operating instructions should be adhered to.
Follow instructions– All operating and use instructions should
be followed.
TO PREVENT THE RISK OF ELECTRIC SHOCK, DO NOT
REMOVE THE COVER (OR BACK). THERE ARE NO USER
SERVICEABLE PARTS INSIDE THIS UNIT.   PLEASE REFER
SERVICING TO QUALIFIED JBL CORPORATION SERVICE PER-
SONNEL.
Do not expose the speakers to liquid or solvent.
Never remove grille covers in order to service the speaker
system. The speaker system does not contain any user serviceable
parts. Refer all servicing to the JBL Technical Support Group.
Do not expose the speaker system to temperature or humidity
extremes, direct sunlight, excessive dust, or vibrations.
Place the speaker system on a stable, level surface. Do not drop,
apply excessive force to the controls, or put heavy objects on top
of the speaker.
If cleaning is required, use a soft dry cloth. If necessary, use a damp
cloth without any solvents.
In order to protect the speaker system, avoid microphone feedback,
continuous output from electronic musical instruments, or distorted
output from any signal source
Do not place the speakers close to fluorescent light sources  or neon
light fixtures.
Although the speakers are magnetically shielded, keep magnetic
storage media (disks and tapes) at least four inches from the speaker
system in order to avoid data loss.
WARNING: To reduce the risk of fire or electric shock, do not expose
this speaker system to rain or moisture.
USE ONLY JBL approved power supplies listed on the product
label.
on stage
FCC Regulations
FCC Declaration of Conformity Statement 
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Radio and Television Interference
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause interference to radio or television
reception, which can be determined by turning the equipment off
and then on, the user is encouraged to try to correct the interference
by one or more of the following measures:
Increase the separation between the equipment and receiver.
Connect the equipment to a different outlet so that the equipment
and receiver are on different branch circuits.
Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by JBL could void 
the user’s authority to operate the equipment.
www.JBL.com
2
3
Page of 19
Display

Click on the first or last page to see other ON STAGE (serv.man7) service manuals if exist.