Read JBL ON STAGE (serv.man3) EMC - CB Certificate online
- Page 9 of 19 -
Order No. 23171
1
GENERAL
—
1.1
SCOPE
—
1.1.1
Equipment covered by this
standard
standard
The product is driven by a digital audio signal and is
therefore considered within the scope of IEC 60950.
therefore considered within the scope of IEC 60950.
—
1.1.2
Additional requirements:
—
Exposure to extreme temperatures,
excessive dust, moisture or
vibration; to flammable gases; to
corrosive or explosive atmospheres
excessive dust, moisture or
vibration; to flammable gases; to
corrosive or explosive atmospheres
This equipment is intended to operate in a "normal"
environment (Offices and homes). Max recommended
ambient temperature (T
environment (Offices and homes). Max recommended
ambient temperature (T
MRA
) as stated by the
manufacturer is 25
°
C.
—
Electromedical equipment
connected to the patient
connected to the patient
This equipment is not an electromedical equipment
intended to be physically connected to a patient.
intended to be physically connected to a patient.
—
Equipment used in vehicles, ships
or aircrafts, in tropical countries, or
at elevations > 2000m
or aircrafts, in tropical countries, or
at elevations > 2000m
This equipment is intended to operate in a "normal"
environment (Offices and homes). Max recommended
ambient temperature (T
environment (Offices and homes). Max recommended
ambient temperature (T
MRA
) as stated by the
manufacturer is 25
°
C.
—
Equipment intended for use where
ingress of water is possible
ingress of water is possible
This equipment is intended to be used in applications
where ingress of water is not regarded possible. The
equipment is non-protected according to IEC 60529.
where ingress of water is not regarded possible. The
equipment is non-protected according to IEC 60529.
—
IP-classification (IEC 60529) (IP)
IP X0.
—
1.2.2
OPERATING CONDITIONS
—
1.2.2.1
Normal load as described in Annex
L or as close as possible to the
most severe normal use
L or as close as possible to the
most severe normal use
Max. undistorted with sign wave signal was 16.1 W,
reduce d to 1/8
reduce d to 1/8
th
Max. and switched to filtered pink noise
per IEC/EN 60065 for maximum normal load.
Refer to Summary of Testing.
Refer to Summary of Testing.
—
1.2.2.2
Rated operating time as assigned
by the manufacturer
by the manufacturer
The manufacturer has not declared a rated operating
time.
time.
—
1.2.2.3
Continuous operation
The equipment is regarded to be for continuous
operation.
operation.
—
Click on the first or last page to see other ON STAGE (serv.man3) service manuals if exist.