Read JBL ON STAGE III IIIP (serv.man2) EMC - CB Certificate online
<12014238 001 >
Page 60 of 77
National Differences
Clause
Requirement − Test
Result – Remark
Verdict
Japanese National Differences according to CB Bulletin No. CB Bulletin No. 109A, December 2005
2.6.5.4
Replacement:
Replace 1st sentence.
Protective earthing connections of CLASS I
EQUIPMENT shall make earlier and break later
than the supply connections in each of the
following:
EQUIPMENT shall make earlier and break later
than the supply connections in each of the
following:
Replaced.
N/A
2.6.101
Addition:
Earthing of CLASS 0I EQUIPMENT
Plugs with a lead wire for earthing shall not be
used for equipment having a rated voltage
exceeding 150 V.
used for equipment having a rated voltage
exceeding 150 V.
For plugs with a lead wire for earthing, the lead
wire shall not be earthed by a clip.
wire shall not be earthed by a clip.
CLASS 0I EQUIPMENT shall be provided with an
earthing terminal or lead wire for earthing in the
external where easily visible.
earthing terminal or lead wire for earthing in the
external where easily visible.
Added.
N/A
3.2.5
Delete 1) in Table 3B.
Deleted.
N/A
4.2.8
Addition:
Add the following informative remark after the last
sentence.
sentence.
Remark - IEC 61965 is also applicable instead of
IEC 60065.
IEC 60065.
Added.
N/A
4.5.1
Addition:
Add the following to suffix 5) as specified in
“Conditions applicable to Table 4A, Parts 1 and 2”.
“Conditions applicable to Table 4A, Parts 1 and 2”.
With regard to Table 4A, insulating materials
complying with Japanese requirements (refer to
Japanese differences for the current IEC 60335-1
(3rd Edition) in CB Bulletin 101B) are also
acceptable.
complying with Japanese requirements (refer to
Japanese differences for the current IEC 60335-1
(3rd Edition) in CB Bulletin 101B) are also
acceptable.
Add a suffix 7) in “Conditions applicable to Table
4A, Parts 1 and 2”.
4A, Parts 1 and 2”.
In the right column of Table 4A, Part 1, add suffix
7) to “50” (K), corresponding to “- without T –
marking” in the left column so as to become
“50
7) to “50” (K), corresponding to “- without T –
marking” in the left column so as to become
“50
7)
”.
Add 7) to Table 4A, Part 2 as follows.
7) This value shall apply only to wiring or cords
complying with relevant IEC standards. Others
shall comply with Japanese requirements (refer to
Japanese differences for the current IEC 60335-1
(3rd Edition) in CB Bulletin 101B).
complying with relevant IEC standards. Others
shall comply with Japanese requirements (refer to
Japanese differences for the current IEC 60335-1
(3rd Edition) in CB Bulletin 101B).
Added.
N/A
Click on the first or last page to see other ON STAGE III IIIP (serv.man2) service manuals if exist.