Read JBL ON BEAT MICRO (serv.man3) EMC - CB Certificate online
Issue Date:
2012-10-23
Page 11 of 50
Report Reference #
E204594-A37-CB-1
IEC 60950-1
Clause
Requirement + Test
Result - Remark
Verdict
TRF No. : IEC60950_1B
This report issued under the responsibility of UL
1.7
Marking and instructions
Pass
1.7.1
Power rating and identification markings
Pass
1.7.1.1
Power rating mark
Pass
Multiple mains supply connections ........................ :
N/A
Rated voltage(s) or voltage range(s) (V) ............... :
Class III. Not required. See
Models and Ratings.
Models and Ratings.
N/A
Symbol for nature of supply, for d.c. only .............. :
N/A
Rated frequency or rated frequency range (Hz) .... :
N/A
Rated current (mA or A) ........................................ :
Class III. Not required. See
Models and Ratings.
Models and Ratings.
N/A
1.7.1.2
Identification markings
Pass
Manufacturer's name or trademark or identification
mark ....................................................................... :
mark ....................................................................... :
1. See CB Certificate 2. See
Marking label 3. Trademark
authorized.
Marking label 3. Trademark
authorized.
Pass
Model identification or type reference ................... :
Refer to the Model information
at the beginning of this Test
Report.
at the beginning of this Test
Report.
Pass
Symbol for Class II equipment only ....................... :
Class III equipment
N/A
Other markings and symbols ................................. :
N/A
1.7.2
Safety instructions and marking
Operating/safety instructions
made available to the user.
made available to the user.
Pass
1.7.2.1
General
Pass
1.7.2.2
Disconnect devices
N/A
1.7.2.3
Overcurrent protective device
N/A
1.7.2.4
IT Power distribution systems
N/A
1.7.2.5
Operator access with a tool
N/A
1.7.2.6
Ozone
N/A
1.7.3
Short duty cycles
N/A
1.7.4
Supply voltage adjustment .................................... :
N/A
Method and means of adjustment; reference to
installation instructions .......................................... :
installation instructions .......................................... :
N/A
1.7.5
Power outlets on the equipment ............................ :
N/A
1.7.6
Fuse identification (marking, special fusing
characteristics, cross-reference) ........................... :
characteristics, cross-reference) ........................... :
N/A
1.7.7
Wiring terminals
Class III equipment
N/A
1.7.7.1
Protective earthing and bonding terminals ............ :
N/A
Click on the first or last page to see other ON BEAT MICRO (serv.man3) service manuals if exist.