Read JBL MUSIC 2 SUB (serv.man2) Service Manual online
80 Crossways Park West
Woodbury, N.Y. 11797
1-800-336-4JBL in the USA
A. System Aural Sweep Test: . . 5.0V Input, 10 Hz to 1 kHz
Height . . . . . . . . . . . . . . . . . . 28.17" (716mm)
MUSIC 2 System.
automatically turns the subwoofer on so you don't have
to; the subwoofer is meant to be left “on” without use of
a power switch*
or computer monitors.
the 230 volt version. The subwoofer's sensitivity to input signals was increased in later versions and these units stay
ON, even when the input signal is absent. This is a normal condition, and does not compromise the safety, integrity, or
dependability of the product in any way.
mounting screws from amplifier bottom.
(2) output wires.
relief plug area in the top cover.
screws from amplifier bottom.
8 x 3/4 Phillips screws from the inner baffle.
replacement cabinet/upper driver assy.
(Part # BASSWAVEENCLKIT)
amp and cabinet is recommended to ensure
airtight seal if the amplifier is removed for any
strain relief plug is inserted back in top cover,
an adhesive, e.g. hot melt glue, silicon seal, epoxy
or similar product must be used on the strain relief
junction to ensure an air tight seal.
refinements are introduced into existing models without
notice as a routine expression of our design philosophy.
For this reason, the Bass2/Basswave Subwoofer may
differ in some respect from its published specifications
and descriptions, but will always equal or exceed the
original specifications unless otherwise stated.