FLIP II (serv.man6) - JBL Audio EMC - CB Certificate (repair manual). Page 9

Read JBL FLIP II (serv.man6) EMC - CB Certificate online

 
Page 7 of 88                           Report No. EFSN13070129E-1 
 
TRF No. IEC60950_1C 
 
 
General remarks: 
The test results presented in this report relate only to the object tested. 
This report shall not be reproduced, except in full, without the written approval of the Issuing testing 
laboratory. 
"(see Enclosure #)" refers to additional information appended to the report. 
"(see appended table)" refers to a table appended to the report. 
 
 
The related applicable CTL, OSM decisions have been considered and the requirements found 
fulfilled
 
 
Throughout this report a 
 comma / 
 point is used as the decimal separator. 
Manufacturer’s Declaration per sub-clause 6.2.5 of IECEE 02: 
The application for obtaining a CB Test Certificate 
includes more than one factory location and a 
declaration from the Manufacturer stating that the 
sample(s) submitted for evaluation is (are) 
representative of the products from each factory has 
been provided ............................................................... : 
 Yes 
 Not applicable 
 
When differences exist; they shall be identified in the General product information section. 
Name and address of factory (ies) .......................... :  Factory 1:  
Guoguang Electric Co., Ltd 
No. 8 Jinghu Road, Xinhua Street, Huadu Reg, 
Guangzhou, 510800, P. R. China 
 
Factory 2: 
TCL TECHNOLY ELECTRONICS (HUIZHOU) CO., 
LTD 
Section 37, Zhongkai High-tech Development Zone, 
Huizhou City, Guang Dong Province, China, 516006. 
General product information: 
 
The unit covered by this report is Portable Wireless speaker with Bluetooth, used with information 
technology equipment 
The unit with two speaker, each speaker is 8ohm, 6W  
The unit is Class III equipment, rated 5Vdc, 1.0A, supplied by approved external power supply, Electronic 
components mounted on PWB, housed with plastic enclosure 
 
Adapter rating: Input 100-240VAC, 50/60Hz, 0.3A; Output 5V DC, 1.0A 
 
Abbreviations used in the report: 
 
- normal conditions   
 
N.C.   
 
 
- single fault conditions 
 
S.F.C 
- functional insulation 
 
OP 
 
 
 
- basic insulation 
 
 
BI 
- double insulation   
 
DI 
 
 
 
- supplementary insulation SI 
- between parts of opposite 
- polarity 
 
 
 
BOP   
 
 
- reinforced insulation 
 
RI 
 
Indicate used abbreviations (if any) 
 
 
 
 
Page of 90
Display

Click on the first or last page to see other FLIP II (serv.man6) service manuals if exist.