ES250PW - JBL Audio Service Manual (repair manual). Page 8

Choose either Wireless or Wired connection, then follow the appropriate instructions.

If your receiver/processor does not contain a Dolby Digital or DTS processor
but has subwoofer outputs:

Line In

Sub In

LFE

L

R

Crossover

[Hz]

Level

Wireless

ID Code

ff

On

O

Low-Pass

Crossover

[Hz]

Level

Line In

Sub In

LFE

L

R

ff

On

O

Low-Pass

Wireless

ID Code

ff

On

O

Low-Pass

If you have a Dolby

®

Digital or DTS

®

receiver/processor with a low-frequency

effects (LFE) or subwoofer output:

NOTE: If your receiver/processor has only one sub out, you may use 
either the L or R input.

1. Connect a subwoofer cable from the subwoofer or LFE output of your receiver

to the Sub In 

C

on the transmitter.

2. Plug the transmitter module’s power supply into the wall outlet, and connect

the included power cord to the transmitter 

A

. Make sure the Transmitter

Antenna 

‚

is extended upward.

3. Set the ID code on the transmitter and subwoofer (

B

and 

∞

) to the 

same position, as described on page 6. When connected properly, the LED
on the top of the subwoofer will be orange.

4. Set the Low-Pass Selector 

¢

to the “Off” position.

NOTES:
You may also connect a variable full-range output from an A/V receiver or
processor, such as a preamp output or second-room output. In this case, 
set the Low-Pass Selector 

¢

to the “On” position and set the crossover

adjustment as described on page 6.

Some receivers have two subwoofer outputs. In that case, use either connector.

Sub In

ID

CODE

DC18V

1234

JBLP2706_ES150-250PW-120om  5/20/08  4:15 PM  Page 5

7