Read JBL DPS 10 (serv.man2) Service Manual online
Limiter (yes/no)
Yes
THD at Max. Output
Power
10
%
Maximum Output Power
Maximum THD as a result of limiting.
Features
Phase Switch (yes/no)
Phase Switch (yes/no)
yes
—
Volume
pot
Taper
(lin/log)
linear
—
Input Configuration
—
Line
In
(L,C,R,AC3,Mono)
L,R
—
Enabled w/Line/Spkr Input
Select Switch
Line Outputs (L,C,R)
L,R
—
Buffered Output / Pre-Volume control
Line-Out Adj. X-over
130-240
Hz
Var-HPF (Pot CCW and CW
positions)
Rear panel Variable xover
Spkr/Hi
Level
In
(L,C,R,mono)
L,R
—
Enabled w/Line/Spkr Input
Select Switch
Spkr Out: Hi Pass Filter
100
Hz
8 ohm Satellite: 6dB/oct
passive xover
Driven from zero ohms source impedance
Signal-Present LED
Bi-Color LED (green=signal/ red=no signal)
Signal-Present Input
Freq.
100
Hz
Nominal
200uF Series Cap on PCB
Signal-Present Level
2
mV
100Hz into Line Input w/ 1 ch.
driven
S i g n a l - P r e s e n t
Bandwidth
1k
Hz
Signal-Present-LPF for noise
immunity
Signal-Present Turn-on
time
1
sec.
Amp connected and AC on, then input signal applied
Auto Mute/ Turn-OFF
Time
15
min.
T before muting, after signal
is removed
Power on Delay time
3
sec.
AC Power Applied
Transients/Pops
Signal-Present Transient
Signal-Present Transient
5
mV-peak
@ Speaker Outputs
Turn-on Transient
500
mV-peak
@ Speaker Outputs
AC Line cycled from OFF to ON
Turn-off Transient
500
mV-peak
@ Speaker Outputs
AC Line cycled from ON to OFF
Efficiency
Stand-by Input Power
Stand-by Input Power
17
Watts
@ nom. line voltage
AC Power Cons.@1W
18
Watts
@ nom. line voltage
Power Cons.@rated
power
107
Watts
@ nom. line voltage
Efficiency
70.09%
%
Relative to 75w output
Protection
Short Circuit Protection
Short Circuit Protection
yes
Direct short at output
Line Fuse Rating
1.25
Amps
Type-T or Slo Blo
5
Amplifier/Subwoofer
PSW-D110/DPS-10
Click on the first or last page to see other DPS 10 (serv.man2) service manuals if exist.