Read JBL CONTROL 1X (serv.man2) User Guide / Operation Manual online
Troubleshooting
If there is no sound from any
of the speakers:
of the speakers:
• Check that receiver/
amplifier is on and a source
is playing.
• Review proper operation of
your receiver/amplifier.
amplifier is on and a source
is playing.
• Review proper operation of
your receiver/amplifier.
If there is no sound coming
from one speaker:
from one speaker:
• Check the “Balance”
control on your receiver/
amplifier.
• Check all wires and con-
nections between receiver/
amplifier and speakers.
control on your receiver/
amplifier.
• Check all wires and con-
nections between receiver/
amplifier and speakers.
• Make sure all wires are
connected. Make sure none
of the speaker wires are
frayed, cut or punctured.
connected. Make sure none
of the speaker wires are
frayed, cut or punctured.
If the system plays at low
volumes but shuts off as
volume is increased:
volumes but shuts off as
volume is increased:
• Check all wires and con-
nections between receiver/
amplifier and speakers.
• Make sure all wires are
connected. Make sure none
of the speaker wires are
frayed, cut or punctured.
nections between receiver/
amplifier and speakers.
• Make sure all wires are
connected. Make sure none
of the speaker wires are
frayed, cut or punctured.
• If more than one pair of
main speakers is being used,
check the minimum imped-
ance requirements of your
receiver/amplifier.
main speakers is being used,
check the minimum imped-
ance requirements of your
receiver/amplifier.
If there is no (or low) bass
output:
output:
• Make sure the polarities
(+ and –) of the left and
right “Speaker Inputs” are
connected properly.
(+ and –) of the left and
right “Speaker Inputs” are
connected properly.
Notice to Purchaser:
JBL assumes no responsibility or lia-
bility for injuries or property damage –
direct, indirect or consequential –
resulting from the improper installa-
tion of Control 1X loudspeakers.
bility for injuries or property damage –
direct, indirect or consequential –
resulting from the improper installa-
tion of Control 1X loudspeakers.
High-Frequency Driver
1/2" Titanium-laminate, shielded
Low-Frequency Driver
4", Shielded
Crossover Frequency
4,000Hz
Frequency Response
80Hz – 20kHz
Sensitivity
89dB
Nominal Impedance
8 Ohms
Recommended Amplifier
Power Range
Power Range
10 – 80 Watts
Dimensions (H x W x D)
9 x 6-1/16 x 5-7/16"
228 x 155 x 139mm
228 x 155 x 139mm
Weight (each)
5.2 lbs/2.4 kg
Specifications
©1999 JBL, Incorporated.
JBL is a registered trademark of JBL, Incorporated.
8/99
Part No. 1111-CTRL1XOM
A Harman International Company
Declaration of Conformity
Kongevejen 194B
DK-3460 Birkerød
DENMARK
DK-3460 Birkerød
DENMARK
declare in own responsibility, that the product described
in this owner’s manual is in compliance with technical
standards:
EN 50081-1:1992
EN 50082-1:1992
Steen Michaelsen
Birkerød. DENMARK. 8/99
Control 1X OM 11/12/99 10:59 AM Page 4