Read JBL CENTURY GOLD User Guide / Operation Manual online
Figures 8 through 10 show two bi-wiring options, single stereo amplifier
and dual stereo amplifier modes. For passive and bi-wire connections, set
the switch to the Normal/Bi-Wire position (Figure 8a).
1. The external “strapping bars” that normally connect the
Century
Gold’s
low-frequency and high-frequency terminals must be removed before
bi-wiring. To remove the shorting straps, simply loosen and slide the bars
off to the side (Figure 11).
2. Never connect two amplifiers to the same loudspeaker without first removing the
strapping bars. Operating two amplifier channels without removing the
strapping bars can seriously damage your amplifiers!
3. If you have hooked up your
Century Gold
loudspeakers in any of
the bi-wire configurations indicated, it is not advisable to use additional
speakers separately or simultaneously.
4. As with conventional one-amplifier connections, make sure that all
speaker cables are the same length.
No.
10
LOW FREQUENCY
JBL INCORPORATED
8500 BALBOA BLVD. NORTHRIDGE, CA USA
8500 BALBOA BLVD. NORTHRIDGE, CA USA
Figure 8 Bi-Wire Connecting Method
AMP
NORMAL/
BI-WIRE
BI-WIRE
Figure 8a Normal/Bi-Wire Position
Bi-AMP
NORMAL/
BI-WIRE
BI-WIRE
HIGH FREQUENCY
LOW FREQUENCY
HIGH FREQUENCY
JBL INCORPORATED
8500 BALBOA BLVD. NORTHRIDGE, CA USA
8500 BALBOA BLVD. NORTHRIDGE, CA USA
Figure 11 Removal of Shorting Straps
AMP
NORMAL/
BI-WIRE
BI-WIRE
HF
LF
LF
HF
Preamp
Stereo amp
LF
Figure 9 One-Amp Bi-Wire
HF
LF
LF
HF
Preamp w/Y-corded output
Stereo amps
LF
Figure 10 Two-Amp Bi-Wire
Important
Bi-Wiring Connections
final cg om 5-15 7/20/98 1:14 PM Page 8
Click on the first or last page to see other CENTURY GOLD service manuals if exist.