BALBOA 10 (serv.man5) - JBL Audio User Guide / Operation Manual. Page 2

Read JBL BALBOA 10 (serv.man5) User Guide / Operation Manual online

MODELS:
BALBOA 10 AND
BALBOA CENTER
The supplied self-adhesive
rubber feet may be attached 
to the bottom corners of your
speakers to protect your 
furniture.
MODEL: BALBOA 30
This model is shipped with
four self-adhesive nonskid
pads that are to be used when
the loudspeaker is intended 
to be placed on a smooth-
surfaced floor, such as tile or
hardwood. Gently lay the
speaker on its side (not its
front or back) on a soft, non-
abrasive surface. Attach each
pad to the bottom of its foot in
the widest portion of the
recessed area.
DO NOT attach the pads if 
the speaker will be placed 
on carpeting.
NEVER drag the speaker to
move it, as this will damage
the pads, the feet and/or the
wood cabinet itself. Always 
lift the speaker and carry it to
its new location.
CAUTION: Floorstanding
(tower) loudspeakers have a
high center of gravity and may
become unstable and tip over
during earthquakes, or if
rocked, tipped or improperly
positioned. If this is a concern,
these speakers should be
anchored to the wall behind
them, using the same proce-
dures and hardware custom-
ary for anchoring bookcases
and wall units. The customer
is responsible for proper
installation and proper selec-
tion of hardware.
Without pad
With pad
Place pads here
SPEAKER PLACEMENT 
(CONTINUED)
MODELS:
BALBOA 10 AND
BALBOA 30
MODEL:
BALBOA CENTER
Speakers and electronics ter-
minals have corresponding (+)
and (–) terminals. It is impor-
tant to connect both speakers
identically: (+) on the speaker
to (+) on the amplifier and (–)
on the speaker to (–) on the
amplifier. Wiring “out of
phase” results in thin sound,
weak bass and poor imaging.
With the advent of multichan-
nel surround sound systems,
connecting all of the speakers
in your system with the cor-
rect polarity remains equally
important in order to preserve
the proper ambience and
directionality of the program
material.
To use the binding-post
speaker terminals, unscrew
the colored collar until the
pass-through hole in the cen-
ter post is visible. Insert the
bare end of the wire through
this hole; then screw the col-
lar down until the connection 
is tight. 
Receiver
Speaker Outputs
–     +
CENTER
–                +
–     +
–    +
–       +
Receiver’s Speaker Outputs
LEFT
LEFT
RIGHT
RIGHT
–       +
SPEAKER CONNECTIONS
Page of 4
Display

Click on the first or last page to see other BALBOA 10 (serv.man5) service manuals if exist.